American Dryer Corp Phase 7.2.2 user manual

0. DRYER SETUP – ALL parameters that pertain to drying are in this menu level.

0.SELECT MODEL – This allows the selection of the heat source applied to the dryer, and whether the dryer is reversing or non-reversing.

GAS REVERSING	GAS NON-REVERSING
STEAM REVERSING	STEAM NON-REVERSING
ELECTRIC REVERSING	ELECTRIC NON-REVERSING

1.SYSTEM TEMP – This selection controls whether the temperature related programs will be operated in Fahrenheit (°F) or Celsius (°C). The programs affected are as follows:

1)Temperature Display Mode

2)Drying Temperatures

3)Cool Down Temperatures

IMPORTANT: The Phase 7 non-coin microprocessor controller (computer) automatically calculates and converts the temperatures in these programs to the previously set value. For example, when changing from °F to °C, if the preprogrammed Cycle “A” drying temperature was set for 160° F, the Phase 7 non-coin microprocessor controller (computer) will change to 71° C (+/- 1° Celsius).

2.ENTER LINT CLEANING FREQUENCY 1 TO 10 HOURS – This selection sets how long the lint cleaning timer will run before prompting the user to “CLEAN LINT”. Once the user is prompted to “CLEAN LINT”, the Phase 7 non-coin microprocessor controller (computer) will allow an additional 2 hours of run time before the dryer is placed into a locked-out state, waiting for the lint drawer to be cleaned.

3.ENTER AUDIO ALERT ON TIMES 0 TO 10 – This selection allows the operator to adjust the amount of signal tones. This parameter (program) affects the tone at the end of the Cool Down Cycle, as well as at the end of the Wrinkle Guard On Time.

4.ROTATION SENSOR – This selection is used to turn the rotational sensor on or off.

5.BOARD ADDRESS 00 TO ZZ – This location is where the board address is defined. This is only used when the Phase 7 non-coin microprocessor controller (computer) is interfaced to a network.

6.AUTO CYCLE TIME OUT 0 TO 99 MINUTES – This selection allows the user to set a maximum time that the auto cycle will run before timing out.

12