American Dryer Corp Phase 7.2.2 user manual Phase Menu Programming Procedure

PHASE 7

MENU PROGRAMMING PROCEDURE

EVERYINDENTED STEPREPRESENTS THE “START/ENTER” KEYBEING PRESSED TO SELECT A MENU ITEM. EVERY MESSAGE WITH A NUMBER BEFORE IT INDICATES THAT IT IS A MENU SELECTION CHOICE. EVERY MESSAGE WITHOUTANUMBER BEFORE IT INDICATES THAT IT IS THE LAST MENU LEVEL.

I.E. MENU FLOW

FROM (“1: SELECT SYSTEM PARAMETERS”)

PRESSING “START/ENTER” PUTS YOU AT (0: DRYER SETUP)

PRESSING “UP ARROW” PUTS YOU AT (1: COOL DOWN SETUP)

PRESSING “DOWN ARROW” PUTS YOU BACK AT (0: DRYER SETUP)

PROGRAMMING MODE:

ENTERING:

MUST BE IN THE “READY” STATE.

PRESS “STOP/CLEAR” AND “UP ARROW” KEY SIMULTANEOUSLY. (THIS WILL GET YOU INTO THE PROGRAMMING MODE.)

EXITING:

PRESS THE “STOP/CLEAR” KEY REPEATEDLY UNTIL THE PHASE 7 NON-COIN MICROPROCESSOR CONTROLLER (COMPUTER) IS BACK TO THE “READY” DISPLAY. THE “STOP/CLEAR” KEY WILL BRING YOU BACK ONE MENU LEVEL AT A TIME. AT THE FIRST MENU LEVEL, IT WILL EXIT THE PHASE 7 NON-COIN MICROPROCESSOR CONTROLLER (COMPUTER) FROM THE PROGRAMMING MODE AND RETURN TO THE “READY” STATE.

NOTES:

THE “UP ARROW” AND THE “DOWN ARROW” KEYS ARE USED TO SCROLL UP AND DOWN A MENU SELECTION.

THE NUMBER KEYS CAN ALSO BE USED TO BRING THE PHASE 7 NON-COIN MICROPROCESSOR CONTROLLER (COMPUTER) DIRECTLY TO A KNOWN MENU ITEM. PRESS THE NUMBER OF THE DESIRED CYCLE, FOLLOWED BY THE “START/ENTER” KEY, TO ENTER THE MENU CHOICE ASSIGNED TO THE NUMBER SELECTED.

26