American Dryer Corp Phase 7.2.2 user manual Gas

SECTION IX

PHASE 7 NON-COIN AUTO CYCLE (PATENT NO. 4,827,627)

CYCLEADJUSTMENT VALUES

Gas	Adjustment
Model	Value
MLG-55	65
MLG-758	60
MLG-75V	70
MLG-78	70
MLG-82	62
MLG-96	70
MLG-122	70
MLG-130	73
MLG-170	68

Electric	Adjustment
Model	Value
MLE-120ES	78
MLE-170SE	70

Steam	Adjustment
Model	Value
MLS-130	65
MLS-170	70

IMPORTANT: If your particular model/dryer dryness levels are not shown in the above charts, contact the Service Department for the appropriate factors for your particular dryer. When doing so, please have the dryer model and serial numbers available.

IMPORTANT: The adjustment values have been preprogrammed by the factory, but can be changed in the field. IF THE PHASE 7 NON-COIN MICROPROCESSOR

CONTROLLER (COMPUTER) SHOULD FAILAND IS BEING REPLACED, THE REPLACEMENT PHASE 7 NON-COIN MICROPROCESSOR CONTROLLER (COMPUTER) MUST BE REPROGRAMMED FOR THE SPECIFIC MODEL SHOWN IN THE ADJUSTMENT VALUE PARAMETERS CHARTS ABOVE. THE ADJUSTMENT VALUE LABEL IS LOCATED ON THE TOP CONTROL PANEL, BEHIND THE KEYBOARD (TOUCH PAD) DISPLAY DOOR.

NOTE: When fine-tuning theAuto Cycle for certain loads, if the clothes comes out wet decrease the adjustment value; if the material comes out too dry, increase the adjustment value.

78