Xerox F116 Transmission from the feeder, Transmission from memory, Communication error codes

MFL 251 523 984_ FAXCENTRE F116_F116 L US.book Page 111 Mercredi, 11. août 2004 4:48 16

Maintenance

Transmission from the feeder

You have the choice between:

•waiting until the transmission takes place at the given time,

•restarting the transmission immediately by pressing ,

•abandoning transmission by pressing . To eject the document, press again.

Transmission from memory

You have the choice between:

•waiting until the transmission takes place at the given time,

•restarting the transmission using the transmission queue. (refer to paragraph Immediately perform transmission from the waiting queue, page 74). In this case, for a document composed of several pages, the transmission will take place from the page where the error occurred,

•abandoning the transmission by deleting the corresponding command in the transmission line (refer to paragraph Deleting a transmission on hold, page 74).

The machine makes at most 5 automatic redials. The non-transmitted document is automatically deleted from the memory and a transmission report is then printed together with an error code and the cause for transmission failure (see the communication error codes).

Communication error codes

The communication error codes appear in the logs and transmission reports.

General codes

Code 01 - Busy or no fax answer

This code appears after 6 unsatisfactory attempts. Call later.

Code 03 - User break

A communication has been stopped by the user pressing the key .

Code 04 - Non programmed number

A number saved as a one-touch key or abbreviated number is not valid-check it. (Example: a delayed transmission was programmed with a one-touch key and this key has been deleted in the meantime).

Code 05 - Scanning default

An incident occurred with the scanner, for example, the sheet is jammed.

Code 06 - machine default

An incident occurred in the machine: no paper, paper jam, opened cover... In the reception mode, this incident appears only if the reception parameter is switched to WITHOUT PAPER (refer to paragraph Reception without paper, page 38).

Code 07 - Disconnected

The link has been cut (bad line). Check the number and try again.

- 111 -

Safety Maintenance Operation Directory Setting up your Getting started Installation Contents machine

Date en cours : 11 août 2004

\\Sct01002\BE31-DOC\DOC 31 - En cours\Travaux en cours\Fax\MFL V 2\LU 251 523 984B MFL_V2 FAXCENTRE F116_F116L XEROX

FR_GB_ESP\Anglais\Maintenance.fm