American Dryer Corp Phase 7.2.2 user manual Programming Instructions, Introduction to Programming

SECTION VI

PROGRAMMING INSTRUCTIONS

A. INTRODUCTION TO PROGRAMMING

The various program selections are stored in the Phase 7 non-coin microprocessor controller (computer) and are broken down into five (5) categories:

0.Language (ENGLISH, FRANCAIS, ESPANOL, ITALIANO, and DEUTSCH).

1.System Parameters (Dryer Setup, Display Setup, Cool Down Setup, and Wrinkle Guard Setup).

2.Preprogrammed Cycles (Keys “A-F”).

This feature allows the operator to have the six (6) most commonly used cycle selections awaiting the push of a single keyboard (touch pad) entry, to start the dryer.

3.Preprogrammed Cycles (“0-40”).

This feature allows the operator to have an additional forty-one (41) preprogrammed cycle selections. These can be started by selecting the cycle number and pressing the “START/ENTER” key.

4.Default Settings (returns ALL programmable parameters to factory default settings).

Both the preprogrammed cycles and the system parameters (programs) have been preprogrammed by the factory with the parameters shown in Section VII of this manual. The various program selections for the preprogrammed cycles and system parameters are outlined in Section III of this manual.

ALL program changes for the preprogrammed cycles and system parameters (programs) are done through the keyboard (touch pad) selection keys on the front of the control panel.

ENTERING THE PROGRAMMING MODE:

First, make sure that no cycle is in progress and that the light emitting diode (L.E.D.) display reads “READY”, and then press the “STOP/CLEAR” key and the “UP ARROW” key at the same time. This will put the Phase 7 non-coin microprocessor controller (computer) into the Programming Mode.

EXITING THE PROGRAMMING MODE:

The “STOP/CLEAR” key will return you to the previous menu level. Continue to press the “STOP/CLEAR” key until the Phase 7 non-coin microprocessor controller (computer) is completely out of the Programming Mode.

23