Ositech comm 614006-001 manual Expected Tuple not found, Must be an AT .286 or higher system

Page 52

Section Four

The expected Tuple not found

The network driver has been unable to locate configuration information needed to operate the network. Run the diagnostic software accompanying the Trumpcard to correct this situation.

Must be an AT (.286) or higher system

The network driver requires that the computer, as a minimum, is a PC AT (80286) or higher.

Hardware not responding

Run the diagnostic software accompanying the Trumpcard PC Card to verify that the hardware is functioning properly.

No Media Cable Connected

The network driver was instructed to auto detect the media cable connected, but no media connection was detected. If a media connection does exist, run the diagnostics accompanying the Trumpcard to verify that the hardware is functioning properly.

4 - 10

Trumpcard Ethernet LAN

Image 52
Contents Trumpcard Ethernet LAN User’s Guide and ReferenceHow To Contact Us CopyrightPreface FCC Notice Contents Appendices Introduction Section OneTrumpcard Ethernet LAN Preparing for Installation Hardware InstallationSection Two Installing the Trumpcard Ethernet LAN Connecting to 10BaseT Twisted Pair Networks Media Access Module 10BaseT Network Connection Interface Cabling and Pinout Twisted Pair Network Characteristics ConcentratorsConnecting to 10Base2 Thin Ethernet Networks Thin Coax Ethernet Segment Meter segments unless all LAN adapters and repeaters Thin Ethernet Network Characteristics Characteristics Standard Length Extended Length SegmentActivity LED RED Media Access Module LED IndicatorsLink LED Green Section Two Operation Section ThreeSocket Services and Card Services Multi-Function ConfigurationNetwork Software Installation Banyan Vines\DOS\OTCETH.DOS \DOSFTP Software LanWatch DEVICE=C\DECNET\PROTMAN.SYS /IC\DECNETDEVICE=C\DECNET\OTCETH.DOS Call \DECNET\STARTNETIBM LAN Server Operation IBM LAN Support Program \LSP\NETBIND Microsoft Windows for Workgroups Microsoft LAN Manager\LANMAN\NETBIND \WFW\311 PATH=C\NOVELL\NET.CFG OSI$OTCETHDEVICE=C\WINDOWS\IFSHLP.SYS \WINDOWS\NETSTARTCD \NOVELL LSLMicrosoft Windows NT Network\DOS\NET Start Microsoft Workgroup Connection for DOSPRIORITY=MS$NETBEUI MS$OTCETH$NIC Ndis Generic BINDINGS=MS$OTCETH$NIC LANABASE=0Novell Netware for DOS PathNetware Netx Novell Netware for OS/2 \NETWARE\OS2\OTCETH.SYSNovell Unixware Dlpi Driver Accompanying the PC Card for more details SCO Unix LLI Driver Init Single User Mode Appendices Section FourFrame frame type Appendix a ODI KeywordsMedia media type INT interrupt level MEM memory locationPort I/O port Node Address nnnnnnnnnnnnProtocol named protocol protocol id frame type Socket socket numberLook Ahead Size look ahead value Frame ETHERNET802.3 Media 10BASET Exclusive Dislink INTMEDIA= media type Appendix B Ndis KeywordsMEM= memory location INTERRUPT= interrupt level IOBASE= I/O portNETADDRESS= ‘nnnnnnnnnnnn’ SOCKET= socket numberPROTOCOL.INI Example DRIVERNAME=STACK$ BINDINGS=OSITECHNIFAppendix C Messages Failed to register with Multi-Function ManagerFailed to register with Card Services Unable to configure TrumpcardOnly supported on Pcmcia 2.x or higher Socket/Card Services Pcmcia adapter not foundExpected Tuple not found Must be an AT .286 or higher systemHardware not responding No Media Cable ConnectedODI Specific Error Messages Section Four