Ositech comm 614006-001 manual Installing the Trumpcard Ethernet LAN

Page 10

Section Two

Installing the Trumpcard Ethernet LAN

The Trumpcard Ethernet LAN can be inserted into a computer whether the power is ON or OFF.

Follow these steps:

•Orient the Trumpcard so that the 68-pin connector is next to the PCMCIA slot of the computer.

•Insert the Trumpcard into the slot until it is firmly seated.

Note:

These are general installation instructions that apply to most

computers. Please refer to the manual accompanying your computer

for any additional instructions on installing PC Card adapters.

Note:

The Trumpcard is keyed to go in one way only. If you feel resistance

before it is fully inserted, remove it, turn it over, and re-insert it.

Installing the Trumpcard

2 - 2

Trumpcard Ethernet LAN

Image 10

Contents Trumpcard Ethernet LAN User’s Guide and ReferenceHow To Contact Us CopyrightPreface FCC Notice Contents Appendices Introduction Section OneTrumpcard Ethernet LAN Preparing for Installation Hardware InstallationSection Two Installing the Trumpcard Ethernet LAN Connecting to 10BaseT Twisted Pair Networks Media Access Module 10BaseT Network Connection Interface Cabling and Pinout Twisted Pair Network Characteristics ConcentratorsConnecting to 10Base2 Thin Ethernet Networks Thin Coax Ethernet Segment Meter segments unless all LAN adapters and repeaters Thin Ethernet Network Characteristics Characteristics Standard Length Extended Length SegmentActivity LED RED Media Access Module LED IndicatorsLink LED Green Section Two Operation Section ThreeSocket Services and Card Services Multi-Function ConfigurationNetwork Software Installation Banyan Vines\DOS\OTCETH.DOS \DOSDEVICE=C\DECNET\OTCETH.DOS FTP Software LanWatchDEVICE=C\DECNET\PROTMAN.SYS /IC\DECNET Call \DECNET\STARTNETIBM LAN Server Operation IBM LAN Support Program \LSP\NETBIND Microsoft Windows for Workgroups Microsoft LAN Manager\LANMAN\NETBIND \WFW\311 PATH=C\NOVELL\NET.CFG OSI$OTCETHCD \NOVELL DEVICE=C\WINDOWS\IFSHLP.SYS\WINDOWS\NETSTART LSLMicrosoft Windows NT Network\DOS\NET Start Microsoft Workgroup Connection for DOSPRIORITY=MS$NETBEUI MS$OTCETH$NIC Ndis Generic BINDINGS=MS$OTCETH$NIC LANABASE=0Novell Netware for DOS PathNetware Netx Novell Netware for OS/2 \NETWARE\OS2\OTCETH.SYSNovell Unixware Dlpi Driver Accompanying the PC Card for more details SCO Unix LLI Driver Init Single User Mode Appendices Section FourFrame frame type Appendix a ODI KeywordsMedia media type Port I/O port INT interrupt levelMEM memory location Node Address nnnnnnnnnnnnLook Ahead Size look ahead value Protocol named protocol protocol id frame typeSocket socket number Frame ETHERNET802.3 Media 10BASET Exclusive Dislink INTMEDIA= media type Appendix B Ndis KeywordsMEM= memory location NETADDRESS= ‘nnnnnnnnnnnn’ INTERRUPT= interrupt levelIOBASE= I/O port SOCKET= socket numberPROTOCOL.INI Example DRIVERNAME=STACK$ BINDINGS=OSITECHNIFAppendix C Messages Failed to register with Multi-Function ManagerOnly supported on Pcmcia 2.x or higher Socket/Card Services Failed to register with Card ServicesUnable to configure Trumpcard Pcmcia adapter not foundHardware not responding Expected Tuple not foundMust be an AT .286 or higher system No Media Cable ConnectedODI Specific Error Messages Section Four