Trango Broadband M2400S user manual Basic Configuration via CLI, Access Point Basic Settings

Basic Configuration via CLI

Section 5 Basic Configuration via CLI

This section covers how to utilize the radio’s CLI interface to establish a working wireless link.

In this section, the most common settings using the CLI are discussed. Topics include:

•Access Point Basic Settings

•Subscriber Unit Database Settings

•Subscriber Unit Basic Settings

See Appendix A − Command Set Reference, for a complete listing of CLI commands.

See the “Getting Started” section for a description of how to access the radio using the telnet interface.

Access Point Basic Settings

After logging onto an AP or SU, it is good practice to type the sysinfo command to see the radio’s basic system information. Example (Access Point):

#> sysinfo

[Hardware Version] 8006

[FPGA Version] 04042201 [Checksum] 47231EEE

[Firmware Version] AP 1p0x8H8006D04061502 [Checksum] F8815A5B [Device ID] 00 01 DE 18 6A 05 [S/N] 01600005

[Base ID] 1234 [AP ID] 01

[System Up Time] 0 day(s) 01:37:29 [Opmode] on [Default Opmode] on

[IP] 10.8.1.232 [Subnet Mask] 255.255.255.192 [Gateway] 10.8.1.193 [Login Password] RW

[Httpd Port] 80 [Httpd Status] listen

[Telnetd Port] 23 [Telnetd Status] connected (10.8.0.60,1454) [Tftpd] disabled

[RF Tx Power] 10 dBm [RF Rx Threshold] -80 dBm [MIR Threshold] 5 Mbps

[Ch#01] 2405 Mhz [Ch#02] 2415 Mhz [Ch#03] 2425 Mhz [Ch#04] 2435 Mhz

[Ch#05] 2445 Mhz [Ch#06] 2455 Mhz [Ch#07] 2465 Mhz [Ch#08] 2475 Mhz [Default Channel] 1 e [Active Channel] 1 e

[Broadcast Packet] block [SU to SU] off [TCP/IP for SU] on [Remarks]

[RF Rx] 0 kbps [RF Tx] 0 kbps [Eth Rx] 3 kbps [Eth Tx] 5 kbps

Many of these parameters can be changed by the user. A description of each of these changeable parameters, along with the related command is shown in the table below.

!Important! When changing settings, it is usually necessary to type the save ss command in order to update the radio’s flash memory. If you do not type the save ss command, the setting will be lost the next time the

radio is rebooted or power cycled.

.

	AP SYSTEM INFORMATION PARAMETERS AND RELATED COMMANDS
AP Parameter		Description	Related CLI Command
Device ID		MAC Address of AP	N/A
Base ID		Specifies the cell or cluster to	set baseid <baseid>
		which the AP belongs. Base ID
		must match in AP and SU in	Example:
		order to establish a wireless	#>set baseid aa12
		link.
Trango Broadband Wireless — User Manual M2400S Rev A			Page 21