Trango Broadband M2400S user manual Antenna h v e, Sw 0 onoff, Sw 1 onoff, Sw 2 onoff, Sw 6 onoff

Basic Configuration via CLI

	SU SYSTEM INFORMATION PARAMETERS AND RELATED COMMANDS
SU Parameter		Description	Related CLI Command
			#>freq 3
			This command will change the channel of the AP to
			3. Use the antenna command to select an antenna
			polarization.
			antenna [<h v e>]
Broadcast Packet Filter		This software switch (0)	sw 0 [<onoff>]
		enables/disables the blocking
		of Ethernet control packets,	Example:
		except ICMP and ARP, to	#>sw 0 on
		reduce the amount of
		unnecessary overhead
		introduced into the wireless
		link. Default setting is ON.
AP Autoscan		This software switch (1) is to	sw 1 [<onoff>]	(default is on)
		turn AP autoscan on or off.
TCP/IP for AP		This software switch (2)	sw 2 [<onoff>]	(default is on)
		when on, allows users at the
		AP side of the network to	Example:
		telnet or HTTP into the SU.	#>sw 2 off
TCP/IP for Local		This software switch (6)	sw 6 [<onoff>]	(default is on)
Ethernet Port		when on, allows users on the
		wired side of the SU to telnet
		or HTTP into the SU
		regardless of the Opmode.
Remarks		User definable radio	remarks [<remarks>]
		information (i.e. customer	Example:
		name, address of installation,	#>remarks 678 Oak Ave
		and so on). A maximum of
		28 characters can be stored.
Counters:		This is an average of wired	Informational Parameter
RF TX	RF RX	and wireless, transmitted and
Eth TX	Eth RX	received, traffic in kilobits
		per second.

Trango Broadband Wireless — User Manual M2400S Rev A Page 27