Trango Broadband M2400S user manual Configure Basic SU Parameters, SU Basic Setup

Page 19

Basic Configuration via Browser Interface

Configure Basic SU Parameters

In order to establish a working link, the Base ID in the SU must match the Base ID of the AP.

SU Basic Setup:

1.Connect to the SU (see Getting Started) and open the Configuration page.

2.Set Base ID (must match the AP).

3.Set IP, subnet, and gateway, or leave at default settings. Keep in mind if you change the IP Settings of the radio you will loose your HTTP session when you save and activate.

4.Ensure default Opmode is "ON."

5.Save and Activate Settings.

6.If Opmode is “OFF,” click Opmode ON.

At this point, if all parameters have been set correctly and the radios are within range, a wireless link between the AP and SU will automatically become established. Once this occurs the SU will be in “associated” status.

Allow approximately 60 seconds for the radios to complete the boot-up cycle and to associate. If the AP is busy servicing many SUs, the association process may take slightly longer.

Trango Broadband Wireless — User Manual M2400S Rev A

Page 15

Image 19

Contents M2400S GHz Wireless Broadband System Table of Contents Table of Figures Canada Warranty Information Firmware NotificationsPreface FCC InformationOverview IntroductionSmartPolling & Bandwidth Throttling Auto-retransmit Feature ARQM2400S AP and SU Hardware Components Hardware OverviewGetting Started Connections and PowerRadio Management Concepts Wiring DiagramOpmode Browser InterfaceBrowser Interface Login Primary Features and Pages of the Browser Interface Telnet ip address of radio Command Line InterfaceTroubleshooting Configuring the AP Subscriber Unit Database Sudb Basic Configuration via Browser InterfaceThis section you will CIR Down Creating an SU in the SudbActive Channel/Polarization Configure Other Basic AP ParametersDefault Opmode IP Address, Subnet Mask, and GatewayBasic Configuration via Browser Interface SU Basic Setup Configure Basic SU ParametersLink Control LED SummaryRF Link Loopback Test SU Ranging Test Advanced SetupOther Key Parameters Site Survey Access Point Basic Settings Basic Configuration via CLISet baseid baseid Set apid apid 00-FF in HEX Set defaultopmode on or offSet defaultopmode on time sec Ipconfig new ip new subnet mask newSw 3 onoff default is off Power set minmaxdBmSw 0 onoff default is on On/off commandSudb add suid prreg device id suid SU ID Subscriber Unit Database SettingsSw 7 onoff default is on Remarks remarksSubscriber Unit Basic Settings Targetap apid SU System Information Parameters and Related CommandsSw 2 onoff Antenna h v eSw 0 onoff Sw 1 onoffPart Number QTY Mounting HardwareCabling and Grounding Considerations Installation NotesDeployment Command survey time antennaSite Selection Site Survey Example AP Search and SU Antenna AlignmentAP Search Rssi Command for Antenna AlignmentSU Alignment Using LEDs Link Management CommandsSu ping suid Su linktest suid Su suidSu testrflink suid SU Management from AP ARQ with Selected Repeat and Multirate FeatureRadio Management Access Via TCP/IP ManagementSu password suid all rw ro new password new password Loading Multiple SU’s into Sudb using Dload CommandSu ipconfig suid new ip new subnet new gateway AP Bandwidth Monitoring Snmp SetupObjects for Monitoring and Control SU Bandwidth MonitoringManagement Command Radio Description Access Appendix a Command Set ReferenceReboot unit Ro/rw Remarks Su ipconfig suid new IP new Default = Tftpd Radio Transmit Specifications Appendix B SpecificationsReceiver Specifications Standard External Power Supply Ethernet I/O SpecificationsPower Specifications Mechanical and Environmental SpecificationsIntegrated Antenna AP Standard External Power-over-Ethernet Junction BoxIntegrated Antenna SU