Trango Broadband M2400S user manual Troubleshooting

Page 14

Getting Started

#>

!NOTE: The majority of the CLI commands will be covered throughout this text as well as in Appendix A − Command Set Reference.

Troubleshooting

If you cannot telnet into the radio or open a browser session, check cable connections, ensure proper use of cross- over vs. straight-through cable, and ensure PC’s subnet is routable to radio’s IP address. If you still cannot access the radio’s management interfaces, consult the troubleshooting guide, which is available at www.trangobroadband.com in the Technical Support area of the website.

Trango Broadband Wireless — User Manual M2400S Rev. A

Page 10

Image 14

Contents M2400S GHz Wireless Broadband System Table of Contents Table of Figures FCC Information Warranty Information Firmware NotificationsPreface CanadaIntroduction OverviewAuto-retransmit Feature ARQ SmartPolling & Bandwidth ThrottlingHardware Overview M2400S AP and SU Hardware ComponentsConnections and Power Getting StartedWiring Diagram Radio Management ConceptsBrowser Interface OpmodeBrowser Interface Login Primary Features and Pages of the Browser Interface Command Line Interface Telnet ip address of radioTroubleshooting This section you will Basic Configuration via Browser InterfaceConfiguring the AP Subscriber Unit Database Sudb Creating an SU in the Sudb CIR DownIP Address, Subnet Mask, and Gateway Configure Other Basic AP ParametersDefault Opmode Active Channel/PolarizationBasic Configuration via Browser Interface Configure Basic SU Parameters SU Basic SetupLED Summary Link ControlRF Link Loopback Test Advanced Setup SU Ranging TestOther Key Parameters Site Survey Set baseid baseid Basic Configuration via CLIAccess Point Basic Settings Ipconfig new ip new subnet mask new Set defaultopmode on or offSet defaultopmode on time sec Set apid apid 00-FF in HEXOn/off command Power set minmaxdBmSw 0 onoff default is on Sw 3 onoff default is offRemarks remarks Subscriber Unit Database SettingsSw 7 onoff default is on Sudb add suid prreg device id suid SU IDSubscriber Unit Basic Settings SU System Information Parameters and Related Commands Targetap apidSw 1 onoff Antenna h v eSw 0 onoff Sw 2 onoffMounting Hardware Part Number QTYInstallation Notes Cabling and Grounding ConsiderationsSite Selection Command survey time antennaDeployment AP Search and SU Antenna Alignment Site Survey ExampleRssi Command for Antenna Alignment AP SearchSu ping suid Link Management CommandsSU Alignment Using LEDs Su suid Su linktest suidSu testrflink suid Management ARQ with Selected Repeat and Multirate FeatureRadio Management Access Via TCP/IP SU Management from APSu ipconfig suid new ip new subnet new gateway Loading Multiple SU’s into Sudb using Dload CommandSu password suid all rw ro new password new password SU Bandwidth Monitoring Snmp SetupObjects for Monitoring and Control AP Bandwidth MonitoringManagement Appendix a Command Set Reference Command Radio Description AccessReboot unit Ro/rw Remarks Su ipconfig suid new IP new Default = Tftpd Receiver Specifications Appendix B SpecificationsRadio Transmit Specifications Mechanical and Environmental Specifications Ethernet I/O SpecificationsPower Specifications Standard External Power SupplyIntegrated Antenna SU Standard External Power-over-Ethernet Junction BoxIntegrated Antenna AP