Schumacher IP-1800I Using the Inverter, Powering a 120V AC Device, Risk of electric shock

Page 10

5.3Using the Inverter

It is important to know the continuous wattage of the device you plan to use with the inverter. The Instant Power™ must be used with devices drawing 400 watts or less. If the wattage is not marked on the device, use only devices that draw less than 4 Amps of AC current.

Devices like TVs, fans or electric motors require additional power to start

(commonly known as the “starting or peak power”). The Instant Power™ can supply a momentary surge in wattage; however even devices rated less than the maximum 400 watts can exceed the inverters surge capabil- ity and cause an automatic overload shutdown.

Do not use the inverter with a product that draws a higher wattage than the inverter can provide, as this may cause damage to the inverter and the product.

Make sure the device you are using is compatible with a modified sine wave inverter.

Always run a test to establish whether the inverter will operate a particular piece of equipment or device.

NOTE: In the event of a power overload, the inverter is designed to auto- matically shut down. This safety feature prevents damaging the inverter while testing devices and equipment with the 400 watt range.

NOTE: If powering more than one device, start one device at a time to avoid a power surge and/or inverter overload. The surge load of each device should not exceed the inverter’s continuous operation wattage rate.

5.4Powering a 120V AC Device

To operate a 120V AC device:

1.Ensure the battery clips are securely clipped on the storage holders.

2.Plug the 120V AC device into the AC power outlet, and push the In- verter Switch ON.

NOTE: the CHARGING LED also functions as the INVERTER ON LED

. When you push the inverter switch to the ON position, the LED will light.

3.If the device does not operate properly when first connected to the inverter, push the inverter rocker switch ON (I), OFF (0), and ON (I) again in quick succession. If this procedure is not successful, it is likely that the inverter does not have the required capacity to operate the device intended.

4.Charge the Instant Power™ as soon as possible after each use.

Risk of electric shock.

Incorrect operation of your inverter may result in damage and personal injury. The inverter output is 120V AC and can shock or electrocute the same as any ordinary household AC wall outlet.

6

Image 10
Contents Guide D’UTILISATION Page Índice Table DES Matières PartiePage Personal Precautions Important Safety InstructionsRisk of electric shock or fire Control Panel Internal Battery Fully Charged LED IndicatorsJump Starting a Vehicle Engine Before Using the Inverter Important Safety InstructionsOperating Instructions Risk of ExplosionPowering a 120V AC Device Using the InverterRisk of electric shock Powering a 12V DC Device Appliance Type Estimated Wattage Estimated Usage TimeStorage Light ReplacementFlex-Light Charge Immediately After Purchase Keep Fully ChargedTroubleshooting Problem Possible Cause REASON/SOLUTION SpecificationsInverter Specifications AccessoriesPage Advertencia El riesgo de descarga eléctrica o incendio Instrucciones Importantes DE SeguridadPrecauciones Personales Tablero DE Control Cargada Para arrancar el motor del vehículo Instrucciones DE OperaciónRiesgo de explosión Uso del Inversor Riesgo de descarga eléctricaPara hacer funcionar un aparato de 12V de CD Reemplazo De La Luz Page Especificaciones del Inversor EspecificacionesAccesorioS Page Page Précautions Personnelles Consignes DE Sécurité ImportantesRisque de choc électrique ou d’incendie Risque de gaz explosifsPanneau DE Contrôle Indicateur à DEL Chargement DE LA Batterie Interne DE L’ Instant PowerComplètement Chargée Charge de la batterie interne à l’aide du chargeur intégréConsignes D’UTILISATION Risques d’explosionUtilisation de l’onduleur Alimenter un appareil 120V CARisques de chocs électriques Alimenter un appareil 12 V CCRemplacement De L’ampoule Lampe FlexibleTableau DE Dépannage Problème Cause Possible RAISON/SOLUTION Caractéristiques Problème Cause Possible RAISON/SOLUTIONAccessoires Spécifications de l’onduleur