Tandberg Data Tandberg LTO2 manual Loading the Cartridge, Loading to Magazine

3.3 Loading the Cartridge

This section describes the method of loading the cartridges.

In this device the slot numbers are assigned to the magazine and internal fixed slots as illustrated below.

Rear of device

10	7
(Top of device)	6
9
8	5
	4
Drive	3
	2
	1

Figure 3-4 Slot Logical Numbers

Front of device

Important

The Tandberg LTO2 Autoloader w/BCR requires a free slot used to swap cartridge during the inventory scan process. Thus the maximum cartridge capacity of the Autoloader w/BCR is changed from 10 to 9 and you can not use slot 10 that is a free slot. But if you prefer to use 10 cartridges, the BCR function neet be disabled.

In this case, please contact your nearest Customer Support Center.

3.3.1 Loading to Magazine

A maximum of 7 cartridges can be loaded into the magazine.

Follow the procedure described below to load the cartridges into the magazine.

1.Load the cartridges into the magazine in the proper orientation as shown in the figure 3-5. (The insertion direction is marked on the label on the side of the magazine.)

2.A "click" locking sound will be heard when the cartridge is inserted to the back. Up to seven cartridges can be mounted on a magazine.

Perform the following procedures to mount a cartridge on a magazine:

Tip

When inserting the cartridge, be certain to push it in until it locks with a "click." If the cartridge is not properly locked, it could fall out from the magazine.

- 16 -