Nortel Networks 4134 quick start Installing a Small Module in the Voice Carrier Medium Module

Page 43

Installing the interface modules 43

2Loosen the captive screw at the top of the center slot module guide.

3Remove the center slot module guide. The following figure shows the removal of the center slot guide.

4Align the Large Module with the slot and the slot module guides on the outside edges of the slot.

5Slide the module into the chassis until its connector panel touches the chassis back panel.

6Push gently, but firmly, to seat the connector on the interface module in the chassis back panel.

7Ensure the levers on the module are flush with the front panel of the Secure Router 4134.

8Use a Phillips screwdriver to tighten the two captive screws to secure the module to the chassis.

--End--

Installing a Small Module in the Voice Carrier Medium Module

Ensure you securely install the Voice Carrier Medium Module in the Secure Router 4134 chassis before you install Small Modules in the Voice Carrier Medium Module. For instructions to install the Voice Carrier Medium Module in the chassis, see “Installing a Medium Module” (page 42).

If you are working with 2- or 4-port FXS or FXO Small Modules, ensure you read the safety messages related to the FXS and FXO interface modules. See “Foreign Exchange Station (FXS) Interface Modules” (page

17)and “Foreign Exchange Office (FXO) Interface Modules” (page 18).

Nortel Secure Router 4134

Quick Start

NN47263-100 02.01 Standard

18 February 2008

Copyright © 2007, 2008 Nortel Networks

Image 43

Contents Quick Start Page Contents Introduction Power cord warning statement Copyright 2007, 2008 Nortel Networks FCC statement USA only International Regulatory Statements of ConformityCE marking statement Europe only EN 55022 statements TIA-968-AEN 300386 statement EN 55024 statementBsmi statement Taiwan only Vcci statement Japan/Nippon onlyMIC notice Republic of Korea only Información NOM unicamente para México National Safety Statements of ComplianceEN 60950 statement NOM statement Mexico onlyDenan statement Japan/Nippon only National Environmental Statements of ComplianceRoHS Directive Compliance Statement Weee Directive Compliance Statement Safety messagesWarnung Warnung Hardware Notice Risiko einer Augenverletzung durch Laser Foreign Exchange Station FXS Interface ModulesForeign Exchange Office FXO Interface Modules Personal safety and equipment protectionModule protection Electrostatic discharge Cables and connectors protectionAntistatic material Interface modules FeaturesNew in this release Navigation IntroductionIntroduction Secure Router 4134 installation and initial configuration Secure Router 4134 installation and initial configuration Copyright 2007, 2008 Nortel Networks Secure Router 4134 installation and initial configuration Step Action Unpacking and inspecting the Secure Router 4134 chassisSecure Router 4134 accessories Accessory Function Verified Installing a power supply modulePrerequisites Installing the mounting brackets on the chassisAverage time to install mounting brackets 2 minutes Prerequisites Installing the chassis Risk of injury Grounding the chassis Grounding the chassis Achtung Installing the interface modules Slot numbering legend printed on the Secure Router Foreign Exchange Office FXO Interface Modules Installing a Small ModuleInstalling a Large Module Installing a Medium ModuleInstalling a Small Module in the Voice Carrier Medium Module Voice Carrier Medium Module slot numbering Prerequisites Connecting AC power cables Connecting power cablesConnecting DC power Average time to install one DC power cable 3 minutes Switch off the DC power source Copyright 2007, 2008 Nortel Networks End Verifying a successful installation Powering up the routerLogon prompt appears on the console screen Copyright 2007, 2008 Nortel Networks Connecting a terminal for local access Configuring the Secure Router 4134 for remote accessEstablishing remote access Login admin Password setup Using SSH for remote accessEnable Changing the default administrator passwordChanging the default administrator password Configuring the Secure Router 4134 for remote access Appendix Environmental requirements Environmental requirements Class a device caution statement Appendix Translations of safety messagesCuidado Qualified service personnel warning statementAviso Overcurrent warning statementCover plate warning statement Power cord warning statement Peligro Page Quick Start