Nortel Networks 4134 quick start Quick Start

Page 70

Nortel Secure Router 4134

Quick Start

Copyright © 2007, 2008 Nortel Networks

All Rights Reserved.

Release: 10.1

Publication: NN47263-100

Document status: Standard

Document revision: 02.01

Document release date: 18 February 2008

To provide feedback or to report a problem in this document, go to www.nortel.com/documentfeedback.

www.nortel.com

The information in this document is subject to change without notice. The statements, configurations, technical data, and recommendations in this document are believed to be accurate and reliable, but are presented without express or implied warranty. Users must take full responsibility for their applications of any products specified in this document.

This document is protected by copyright laws and international treaties. All information, copyrights and any other intellectual property rights contained in this document are the property of Nortel Networks. Except as expressly authorized in writing by Nortel Networks, the holder is granted no rights to use the information contained herein and this document shall not be published, copied, produced or reproduced, modified, translated, compiled, distributed, displayed or transmitted, in whole or part, in any form or media.

Sourced in Canada, the United States of America, and India.

*Nortel, the Nortel logo, and the Globemark are trademarks of Nortel Networks.

All other trademarks are the property of their respective owners.

ATTENTION: Before unpacking, installing, or using the Secure Router 4134, ensure you read the section about regulatory information and general safety precautions in the first chapter of this guide.

Image 70

Contents Quick Start Page Contents Introduction Power cord warning statement Copyright 2007, 2008 Nortel Networks International Regulatory Statements of Conformity FCC statement USA onlyTIA-968-A CE marking statement Europe only EN 55022 statementsEN 55024 statement EN 300386 statementBsmi statement Taiwan only Vcci statement Japan/Nippon onlyMIC notice Republic of Korea only NOM statement Mexico only National Safety Statements of ComplianceEN 60950 statement Información NOM unicamente para MéxicoDenan statement Japan/Nippon only National Environmental Statements of ComplianceRoHS Directive Compliance Statement Safety messages Weee Directive Compliance StatementWarnung Warnung Hardware Notice Foreign Exchange Station FXS Interface Modules Risiko einer Augenverletzung durch LaserForeign Exchange Office FXO Interface Modules Personal safety and equipment protectionModule protection Cables and connectors protection Electrostatic dischargeAntistatic material Features Interface modulesNew in this release Introduction NavigationIntroduction Secure Router 4134 installation and initial configuration Secure Router 4134 installation and initial configuration Copyright 2007, 2008 Nortel Networks Secure Router 4134 installation and initial configuration Unpacking and inspecting the Secure Router 4134 chassis Step ActionInstalling a power supply module Secure Router 4134 accessories Accessory Function VerifiedInstalling the mounting brackets on the chassis PrerequisitesAverage time to install mounting brackets 2 minutes Prerequisites Installing the chassis Risk of injury Grounding the chassis Grounding the chassis Achtung Installing the interface modules Slot numbering legend printed on the Secure Router Installing a Small Module Foreign Exchange Office FXO Interface ModulesInstalling a Medium Module Installing a Large ModuleInstalling a Small Module in the Voice Carrier Medium Module Voice Carrier Medium Module slot numbering Prerequisites Connecting power cables Connecting AC power cablesConnecting DC power Average time to install one DC power cable 3 minutes Switch off the DC power source Copyright 2007, 2008 Nortel Networks End Powering up the router Verifying a successful installationLogon prompt appears on the console screen Copyright 2007, 2008 Nortel Networks Configuring the Secure Router 4134 for remote access Connecting a terminal for local accessEstablishing remote access Using SSH for remote access Login admin Password setupChanging the default administrator password EnableChanging the default administrator password Configuring the Secure Router 4134 for remote access Appendix Environmental requirements Environmental requirements Appendix Translations of safety messages Class a device caution statementQualified service personnel warning statement CuidadoOvercurrent warning statement AvisoCover plate warning statement Power cord warning statement Peligro Page Quick Start