Nortel Networks 4134 quick start Connecting DC power

Page 47

Connecting power cables 47

Procedure steps

Step Action

1Insert the female end of an appropriately rated AC power cord in the AC receptacle on the rear panel of the Secure Router 4134, as shown in the following figure.

2Insert the male end of the power cord in a standard 110/220 V AC power outlet.

CAUTION

Ensure you use an appropriately rated AC power cord only. Do not use an extension cord.

CAUTION

ACHTUNG

Stellen Sie sicher, dass Sie nur ein angemessen bewertetes Netzkabel für Gleichstrom verwenden. Verwenden Sie kein Verlängerungskabel.

--End--

Connecting DC power

The following figure shows the location of the terminal block on the DC power supply module.

Nortel Secure Router 4134

Quick Start

NN47263-100 02.01 Standard

18 February 2008

Copyright © 2007, 2008 Nortel Networks

Image 47

Contents Quick Start Page Contents Introduction Power cord warning statement Copyright 2007, 2008 Nortel Networks FCC statement USA only International Regulatory Statements of ConformityCE marking statement Europe only EN 55022 statements TIA-968-AEN 300386 statement EN 55024 statementMIC notice Republic of Korea only Vcci statement Japan/Nippon onlyBsmi statement Taiwan only Información NOM unicamente para México National Safety Statements of ComplianceEN 60950 statement NOM statement Mexico onlyRoHS Directive Compliance Statement National Environmental Statements of ComplianceDenan statement Japan/Nippon only Weee Directive Compliance Statement Safety messagesWarnung Warnung Hardware Notice Risiko einer Augenverletzung durch Laser Foreign Exchange Station FXS Interface ModulesModule protection Personal safety and equipment protectionForeign Exchange Office FXO Interface Modules Electrostatic discharge Cables and connectors protectionAntistatic material Interface modules FeaturesNew in this release Navigation IntroductionIntroduction Secure Router 4134 installation and initial configuration Secure Router 4134 installation and initial configuration Copyright 2007, 2008 Nortel Networks Secure Router 4134 installation and initial configuration Step Action Unpacking and inspecting the Secure Router 4134 chassisSecure Router 4134 accessories Accessory Function Verified Installing a power supply modulePrerequisites Installing the mounting brackets on the chassisAverage time to install mounting brackets 2 minutes Prerequisites Installing the chassis Risk of injury Grounding the chassis Grounding the chassis Achtung Installing the interface modules Slot numbering legend printed on the Secure Router Foreign Exchange Office FXO Interface Modules Installing a Small ModuleInstalling a Large Module Installing a Medium ModuleInstalling a Small Module in the Voice Carrier Medium Module Voice Carrier Medium Module slot numbering Prerequisites Connecting AC power cables Connecting power cablesConnecting DC power Average time to install one DC power cable 3 minutes Switch off the DC power source Copyright 2007, 2008 Nortel Networks End Verifying a successful installation Powering up the routerLogon prompt appears on the console screen Copyright 2007, 2008 Nortel Networks Connecting a terminal for local access Configuring the Secure Router 4134 for remote accessEstablishing remote access Login admin Password setup Using SSH for remote accessEnable Changing the default administrator passwordChanging the default administrator password Configuring the Secure Router 4134 for remote access Appendix Environmental requirements Environmental requirements Class a device caution statement Appendix Translations of safety messagesCuidado Qualified service personnel warning statementAviso Overcurrent warning statementCover plate warning statement Power cord warning statement Peligro Page Quick Start