Nortel Networks 4134 quick start Installing the chassis

Page 34

34Installing the Secure Router 4134 chassis and hardware components

Procedure steps

Step Action

1Select one of the six possible rack-mounting positions on the sides of the Secure Router 4134.

2Use a #2 Phillips screwdriver to attach a bracket to the desired mounting position on one side of the Secure Router 4134.

3Torque the mounting bracket screws to 3 to 6 in-lb (0.339 to 0.6779 N-m).

4Attach the second bracket to the corresponding position on the opposite side of the Secure Router 4134.

--End--

Installing the chassis

Install the Secure Router 4134 in a standard equipment rack (19 in; 48.26 cm).

Average time to install the Secure Router 4134 chassis in an equipment rack: 2 minutes.

ATTENTION

You must install the Secure Router 4134 in a restricted-access location. You must limit access to the Secure Router 4134 to authorized service personnel only.

ATTENTION

Nortel recommends that you install the chassis (including the power supplies and fan tray) in the equipment rack before you install the ground lug and the optional external interface modules.

WARNING

Do not install the Secure Router 4134 near a standing or running water source or in a high-humidity environment.

WARNING

WARNUNG

Installieren Sie den Secure Router 4134 nicht in der Nähe von stehenden oder fließenden Gewässern oder in einem Gebiet mit sehr hoher Feuchtigkeit.

Nortel Secure Router 4134

Quick Start

NN47263-100 02.01 Standard

18 February 2008

Copyright © 2007, 2008 Nortel Networks

Image 34

Contents Quick Start Page Contents Introduction Power cord warning statement Copyright 2007, 2008 Nortel Networks International Regulatory Statements of Conformity FCC statement USA onlyTIA-968-A CE marking statement Europe only EN 55022 statementsEN 55024 statement EN 300386 statementBsmi statement Taiwan only Vcci statement Japan/Nippon onlyMIC notice Republic of Korea only NOM statement Mexico only National Safety Statements of ComplianceEN 60950 statement Información NOM unicamente para MéxicoDenan statement Japan/Nippon only National Environmental Statements of ComplianceRoHS Directive Compliance Statement Safety messages Weee Directive Compliance StatementWarnung Warnung Hardware Notice Foreign Exchange Station FXS Interface Modules Risiko einer Augenverletzung durch LaserForeign Exchange Office FXO Interface Modules Personal safety and equipment protectionModule protection Cables and connectors protection Electrostatic dischargeAntistatic material Features Interface modulesNew in this release Introduction NavigationIntroduction Secure Router 4134 installation and initial configuration Secure Router 4134 installation and initial configuration Copyright 2007, 2008 Nortel Networks Secure Router 4134 installation and initial configuration Unpacking and inspecting the Secure Router 4134 chassis Step ActionInstalling a power supply module Secure Router 4134 accessories Accessory Function VerifiedInstalling the mounting brackets on the chassis PrerequisitesAverage time to install mounting brackets 2 minutes Prerequisites Installing the chassis Risk of injury Grounding the chassis Grounding the chassis Achtung Installing the interface modules Slot numbering legend printed on the Secure Router Installing a Small Module Foreign Exchange Office FXO Interface ModulesInstalling a Medium Module Installing a Large ModuleInstalling a Small Module in the Voice Carrier Medium Module Voice Carrier Medium Module slot numbering Prerequisites Connecting power cables Connecting AC power cablesConnecting DC power Average time to install one DC power cable 3 minutes Switch off the DC power source Copyright 2007, 2008 Nortel Networks End Powering up the router Verifying a successful installationLogon prompt appears on the console screen Copyright 2007, 2008 Nortel Networks Configuring the Secure Router 4134 for remote access Connecting a terminal for local accessEstablishing remote access Using SSH for remote access Login admin Password setupChanging the default administrator password EnableChanging the default administrator password Configuring the Secure Router 4134 for remote access Appendix Environmental requirements Environmental requirements Appendix Translations of safety messages Class a device caution statementQualified service personnel warning statement CuidadoOvercurrent warning statement AvisoCover plate warning statement Power cord warning statement Peligro Page Quick Start