APC 10-40 KVA 380/400/415 V manual

Note: The U-shaped interconnection brackets are 1-2 mm higher than the opening below the enclosure to inactivate the casters. Therefore, the enclosure must be tilted when placing the U- shaped interconnection brackets under the enclosure.

3. In each side of the same enclosure insert a maximum of nine and a minimum of two M8 screws (not provided) through holes in the bottom of the enclosure and through holes in the U-shaped floor anchoring brackets, and into the pre-drilled floor holes.



Note: See “Prepare for Floor-Anchoring

(optional)” on page 2 if the floor has not been prepared for anchoring.

4.Fasten the screws.

5.Move the adjacent enclosure on its casters close to the enclosure with the U- shaped floor anchoring brackets.





Note: If the additional enclosure is on

its levelling feet, use a forklift or pallet jack to move it into position.

Smart-UPS VT ® 10-40 kVA 380/400/415 V, 208/220 V, 200/208 V Battery Installation 9