APC 10-40 KVA 380/400/415 V manual

Install battery-securing and floor-anchoring brackets



Battery securing bracket





L-shaped floor-anchoring bracket (reuse of transportation bracket)



1.Install the batteries by pushing them all the way into the enclosure.

2.If required, install the battery securing brackets to hold the batteries firmly in place. Note! Do not install the bracket the same way they were positioned when the enclosure arrived. Rotate the brackets 180º and reinstall.

Note: Battery securing brackets are delivered with the UPS or XR Battery Enclosure and installed in front of the batteries. Extra battery securing brackets for additional batteries can be purchased. Refer to kit SUVTOPT003: APC Smart-UPS VT Battery Lock Kit for one Battery Module.

3.Install the L-shaped floor-anchoring bracket (reuse of transportation brackets) by adding four M6 screws and nuts (provided) to the enclosure (only if the optional U-shaped floor anchoring brackets described in this manual have not been chosen).

4.Drill floor holes.

Note: If the floor has not been prepared for anchoring, see “Prepare for Floor-Anchoring (optional)” on page 2.

5.Add a minimum of two M8 screws (not provided) to the anchoring bracket and tighten the screws.

Smart-UPS VT ® 10-40 kVA 380/400/415 V, 208/220 V, 200/208 V Battery Installation