Siemens DataNET Hub (DNH) user manual Setting Network Address, Learning Hint

Setting Network Address, Continued

Learning Hint	See Assigning an IP Address, page 59 to learn how to assign an IP Ad-
	dress.
	2.	To configure the DNH IP address, at the Local > prompt type:
		config address ip xxx.xxx.xxx.xxx
		Where xxx.xxx.xxx.xxx should be replaced with a 12-digit unique
		network address. See Assigning an IP (Internet Protocol) Address
		page 59.
	3.	Press ↵ Enter.
	4.	The following message appears: Configuration change verified
	5.	To configure the DNH subnetmask, at the Local > prompt type:
		config netmask xxx.xxx.xxx.xxx
		Where xxx.xxx.xxx.xxx is the subnet mask for your network. Typi-
		cally, this would be in the range 255.255.0.0 through 255.255.255.0.
	6.	Press ↵ Enter.
	7.	To configure the device id, at the Local > prompt type:
		config deviceid xxx.xxx.xxx.xxx
		Where xxx.xxx.xxx.xxx is typically the IP Address of Hub ‘A’.
	8.	Press ↵ Enter.
	9.	To configure the ip router address at the Local > prompt type: config
		iproute x
		An IP router address is not always required. This command sets the
		address of the IP router to which the hub-half should send IP mes-
		sages whose destinations do not reside on the hub’s own network.
		Your network administrator can help you choose an address.
		This field can be left to the default setting of 000.000.000.000 if an IP
		router is not used
	10.	Press ↵ Enter.
		This completes the necessary DNH Configuration. To display the
		current settings, type at Local > prompt: config display
	11.	Repeat steps 1 through 10 for Hub ‘B’ half.

58 • Data Communications Setup 2000585-001