Toshiba TF 631 manual 97 GB, Power saver stand by

Advanced settings

Power saver (stand by)

The printer unit of your fax machine requires a heat source of approx. 170° C in order to be able to print out documents immediately. This heat source is heated at

15-03-98 SUN 19:56	Standby mode
RESIDUAL MEMORY 100 %

Start the menu

specific intervals in order to maintain the temperature at the required level. This consumes electricity, and the fan also has to run constantly. If you wish to save electric current or prevent the fan noise, you are able to deactivate the permanent heating facility. The heater in such cases would only be activated if a fax document is received or printed out. There is a delay of around 1 minute before documents can be printed out.

Two alternatives are available:

1.COMM. OPTION S 2.LISTS

3.INSTALLATION 4.MENU LIST

/ /

POWER SAVER

01.SUPER P. S.

02.PRINTER P. S.

The first 4 menu items are displayed.

Select a menu item

Make your selection for Power Saver mode

01:see part A

02:see part B

Super Power Saver:

In this alternative, all components which are not required are switched off (almost the entire electronics) and the display is therefore also switched off. These measures reduce the entire power consumption of the fax machine to below 2 VA (Watt). The fax machine resumes its functions as soon as a call is made or as soon as a document is inserted.

The Super Power Saver mode is set either with a delay (which can be adjusted between 1 and 60 minutes) after the last action, or it can be activated by the SUPER POWER SAVER key.

•The Super Power Saver mode cannot be activated when the memory is full (memory display < 100%) and when a fault lamp is lit.

Printer Power Saver:

The printer Power Save mode only switches off the heating facility for the fixing roller and the fan. All other functions are retained. The power consumption in this mode is approx. 15 VA (Watt).

You can use a menu for specifying the period during which the printer Power Saver mode is activated.

A	Super P. S.			Make your selection
				for mode
	POWER SAVER			1. Active after preset delay
				2.	Active after the SUPER POWER
	1.AUTOMATIC				SAVER key is pressed
	2.MAN UAL
				3.	Cannot be activated
	3.OFF
				Select a menu item
				Example: Automatic
	STARTTIME			Make your selection
	TIME	(01-60)MIN		for the delay time
			03	Enter the delay time
				Confirm with START
		STOP		Press STOP, return to standby
	START
				mode
B	Printer P. S.

SET POWER SAVER	Make your selection
	for power saver
1.ON
	1: Power saver on
2.OFF
	2: Power saver off

SET POWER SAVER

TIME PERIOD = 00:00 - 00:00

STOP

START

Select a menu item

Make your selection

period for power saver time Enter 00:00-00:00 to permanently activate the power saver facility (24 hours)

Enter the period

TF 631 TOSHIBA Advanced settings 97 GB