Toshiba TF 461 manual Connection to PABX, obtaining a public line

Installation

Connection to PABX, obtaining a public line

The TF 461 can be connected not only to the public switched telephone network (public line) but also to a PABX. In this case, additional parameters have to be entered.

With PABXs, the public line is obtained in various ways:

• Number	Dial one digit (or several
	digits) in order to obtain
	the public line
•Earth key	Earth potential is
	connected to the voice
	wire(s) in order to obtain
	the public line
• Flash key	With this method of
	obtaining the public line,
	the connection circuit is
	interrupted briefly.

With this method of obtaining the public line, the connection circuit is interrupted briefly.

When the method of obtaining a public line has been entered,

you must always press the key ”R” before the actual number when you dial your fax partner. This is also applicable for saving the fax numbers (see page 38).

If you have problems if your machine is connected to an

extension, please read the “Comments concerning connection to PABXs” under “Further settings” (page 61)

15-03 19:56 M 100% FUNCTION

PROGRAM SETUP DATA

2 x

START

PARAMETER NUMBER =

START

ACCESS OFF

REDIAL

PAUSE

REGISTER RECALL

START

STOP

Standby mode

Start the menu

Confirm with START (2x)

Make your selection

Enter function number

Confirm with START

Set public line

Page through the menu...

Flash function

Earth key function

Code

...until you reach the desired menu item

Confirm with START

Press STOP, return to standby mode

GB 12 Installation TOSHIBA TF 461