5Only after completely pull off the protection strip lo- cated on the left side of the cartridge.
EN
Once you have removed the protection strip, do not shake the toner cartridge any more. Other- wise, it is possible that toner dust will be released into the air.
6Place the toner cartridge into your device. The cartridge should snap securely into position.
7Close the cover. Make sure that the cover snaps securely into position on both sides.
Connecting the Telephone Cable
Your device is an analogue fax device (Group 3). It is not an ISDN device (Group 4), and therefore it can- not be operated directly on an ISDN connection. In order to do this, you need either an analogue adapter or a connection for analogue terminals.
Connect the telephone cable to the device by inserting it in the socket designated with LINE
If you connect your device as extension to a tele- phone system, you must set it for working as an ex- tension (also see Chapter "Telephone connections and additional devices, page 29).
Connecting the Mains Cable
Check whether the mains voltage of your device (in- dicated on the type label) matches the mains voltage available at the setup location.
Insert the mains cable into the connection located on the rear side of the device. Connect the mains cable to the elec- trical socket.
Initial Installation
After you connect your device to the mains, the initial in- stallation commences.
Selecting the Country
Always set the country in which you are operating the machine. Otherwise, your machine is not adapt- ed to the telephone network. If your country is not included in the list, you must select a different setting and use the correct telephone cable for the country. Consult your retailer.
1Press OK.
2Use [ to select the country in which you are operat- ing the device.
3Confirm twice with OK.
Entering Number
Your name and number are added together with date, time and page number at the top edge of each fax transmission (= header).
1Enter your number.
To insert special characters and symbols, press ;ü. Select with [. Confirm with OK.
You can move the cursor using [. Use C to de- lete individual characters.
2Confirm with OK.
Entering Name
1Enter the name using the keys
Enter capital letters by pressing and holding ú button. You can enter special characters using ½.
To insert special characters and symbols, press ;ü. Press ûüto insert language specific special characters. Select with [. Confirm with OK.
You can move the cursor using [. Use C to de- lete individual characters.
2Confirm with OK.
Entering the Date and Time
1Enter the date (two digits for each field), for example 31¦05¦25 for May 31th, 2025.
2Enter the time, e.g. 14 00 for 2 pm.
3Confirm with OK.
10 | Philips LPF 920 · 925 · 935 · 940 |