Part IV: Operation
Programming the Remote Control to Control NetCommand™ A/V Products
Programming Remote Control
To Program the Remote to Control NetCommand A/V Products:
(See NetCommand Supported Devices, page 16, for the list of A/V products supported by the NetCom- mand System.)
1Move the slide switch at the top of the remote to the TV layer.
2Press and hold the POWER button on the remote control.
3Enter the three digit code of 935, and then release the POWER button on the remote control.
4The remote control is now programmed to send NetCommand™ signals to the TV so the TV can control the IEEE
1394 devices and selected older Net- Command™ supported IR devices. See the NetCommand™ guide for details.
Figure 1. Programming the remote to control your Net- Command™ A/V devices.
66