JVC RX-DV31 manual Specifications, FM tuner IHF, AM tuner, General

Page 79

Specifications

 

 

Designs & specifications are subject to change without notice.

 

 

 

 

 

 

 

Amplifier

Output Power

At Stereo operation:

 

Front channels:

80 W per channel, min. RMS, both channels driven into 8 Ω

 

 

at 1 kHz, with no more than 0.9% total harmonic distortion.

 

 

(IEC268-3/DIN)

 

At Surround operation:

 

Front channels:

80 W per channel, min. RMS, driven into 8 Ω

 

 

at 1 kHz, with no more than 0.8% total harmonic

 

 

distortion.

 

Center channel:

80 W, min. RMS, driven into 8 Ω

 

 

at 1 kHz, with no more than 0.8% total harmonic

 

 

distortion.

Surround channels:80 W per channel, min. RMS, driven into 8 Ω at 1 kHz, with no more than 0.8% total harmonic distortion.

Audio (Measured on AC 110 V/120 V/220 V/240 V)

Audio Input Sensitivity/Impedance (1 kHz):

TV, TAPE/CDR, DBS, VCR:

 

240 mV/47 kΩ

Audio Input (DIGITAL IN)* :

Coaxial:

DIGITAL 1

(DBS):

0.5 V(p-p)/75 Ω

 

Optical:

DIGITAL 2

(TV):

–21 dBm to –15 dBm

 

 

 

 

(660 nm ±30 nm)

*Corresponding to Linear PCM, Dolby Digital, and DTS Digital Surround (with sampling frequency—32 kHz, 44.1 kHz, 48 kHz).

Signal-to-Noise Ratio (’66 IHF/DIN):

TV, TAPE/CDR, DBS, VCR:

87 dB/67 dB

Frequency Response (8 Ω):

TV, TAPE/CDR, DBS, VCR:

20 Hz to 20 kHz (±1 dB)

Tone Control:

Bass (100 Hz):

±10 dB ±2 dB

 

 

Treble (10 kHz):

±10 dB ±2 dB

 

Video (Measured on AC 110 V/120 V/220 V/240 V)

Video Input Sensitivity/Impedance (1 kHz):

 

 

Composite video:

DBS IN, VCR IN:

1 V(p-p)/75 Ω

S-video:

DBS IN, VCR IN: (Y:luminance):

1 V(p-p)/75Ω

 

(C:chrominance):

0.286 V(p-p)/75 Ω

Video Output Level/Impedance (1 kHz):

 

 

Composite video:

VCR OUT, MONITOR OUT:

1 V(p-p)/75 Ω

S-video:

VCR OUT, MONITOR OUT:

1 V(p-p)/75 Ω

 

(Y:luminance):

 

(C:chrominance):

0.286 V(p-p)/75 Ω

Component video:

DVD COMPONENT VIDEO OUT:

1.0 V(p-p)/75 Ω

 

(Component-Y):

 

(Component-PB/PR):

0.7 V(p-p)/75 Ω

Color System:

NTSC/PAL

 

Horizontal Resolution:

500 lines

 

Signal-to-Noise Ratio (S/N):

63 dB

 

Synchronize:

Negative

 

 

 

 

FM tuner (IHF)

 

 

Tuning Range:

87.50 MHz to 108.00 MHz

 

 

 

 

AM tuner

 

 

Tuning Range:

531 kHz to 1 602 kHz (at 9 kHz intervals)

 

 

530 kHz to 1 600 kHz (at 10 kHz intervals)

 

 

 

 

General

 

 

Power Requirements:

AC 110 V/127 V/220 V/230 – 240 V , adjustable with the voltage selector,

 

50 Hz/60 Hz

 

Power Consumption:

180 W (in operation)

 

 

5 W (in standby mode)

 

Dimensions (W x H x D):

435 mm x 100 mm x 403.5 mm

 

Mass:

8.4 kg

 

English

74

Page 78 Page 80
Image 79
Page 78 Page 80
Contents LVT1001-014A Home Cinema DVD-AUDIO/VIDEO Control CenterPrecaución Precaução Producto Laser Classe Precaución Ventilación Adecuada RX-DV31SLLocations Precautions Checking the Supplied AccessoriesAdjusting the Voltage Selector General PrecautionsTable of Contents KHz for AM station, MHz for FM station Input mode indicators Sound signal indicatorsFront Panel P. Browsable Still Picture, BonusRemote Control English Rear Panel Antenna Connecting the AM and FM AntennasAM antenna connection FM antenna connectionHow to connect speakers cords Connection diagramConnecting the subwoofer speaker For video connections Connecting Audio/Video Components EnglishAbout connecting cords Setting the color systemDBS tuner connection TV connectionTurn off all the components and the unit before connection CD recorder VCR connectionCassette deck/CD recorder connection Cassette deckDigital connection Putting Batteries in the Remote ControlReplace the cover Selecting the Source to Play Turning On the PowerAdjusting the Volume Basic OperationsChanging the Source Name Listening with headphonesBasic Operations Selecting the Front SpeakersChanging the Display Brightness Turning Off the Power With the Sleep TimerSelecting the Analog or Digital Input Mode Turning Off the Sound TemporarilySelect when the analog sound is distorted Attenuating the Input SignalChanging the digital input mode manually-for DVD Video only Sound signal indicators on the displayREC indicator lights up on the display Press Progressive when DVD is selected as the sourceWhen recording onto the VCR Basic DVD Player Operations Other operation buttons for the DVD player About Resume play Basic DVD Player OperationsAbout Tray Lock Tuning in to Stations Manually Setting the AM Tuner Interval SpacingTuner Operations Channel number is flashing on the display Using Preset TuningTuner Operations Press Memory again while the selectedMono Selecting the FM Reception ModeTuning in to a preset station To restore the stereo effectSpeakers Basic SettingsSetting Speakers Quickly Press SettingPress Memory to finish the setting Setting Basic ItemsOperation buttons Speaker information Basic SettingsOperating procedure Repeat steps 2 and 3 to set other items if necessaryDynamic range compression Low frequency effect attenuatorCrossover frequency Digital input Digital in terminals Video output modeAuto surround Front speaker output balance Sound AdjustmentsPress Adjust Press Control 3 or 2 to adjust the front speaker balanceSubwoofer audio position Sound AdjustmentsTone Speaker output levelsDigital multi-channel 5.1 channel surround Dolby Digital Creating Realistic Sound FieldsDolby surround Dolby Pro Logic Typical multi-channel 5.1-channel reproductionAll Channel Stereo Available Surround modes for each input signalCreating Realistic Sound Fields Creating sound fieldSelecting Surround Modes Activating Surround ModePress Surround Mode About Surround indicatorsDolby Digital DTS Digital Surround Dolby Pro Logic Adjust the speaker output levelsFor using test tone Possible × Impossible ModeDVD Video DVD Audio VCD Svcd DVD Player OperationsDisc Information Playable disc typesVCD, SVCD, and CD consist of tracks DVD Player OperationsDisc structure Playback Control function PBC-VCD and Svcd onlyPress on Screen About the On-screen BarPress Enter Changing the Time IndicationBasic Operation through the On Screen Bar Press on Screen twiceFrom the VCD/SVCD menu with PBC Locating a Desired Scene from Disc MenuPress TOP Menu or Menu From the DVD menuPress Angle repeatedly to select the desired view angle Using the on-screen barSelecting the Subtitle Language Press AnglePress Audio repeatedly to select the desired audio language Selecting the Audio LanguageSelecting the Audio Channel Press AudioPress TITLE/GROUP Playing from a Specified Position on DiscPress Audio repeatedly to select the desired audio channel Locating a desired title/groupTo correct a misentry Use the number buttons 0 9 to enter the timePress page repeatedly to select a desired still picture Press 8 oncePress 8 repeatedly Press ¡ orSelect a bonus group ZoomingPress Zoom Playing back a bonus groupPress VFP Press cursor 3 or 2 repeatedly to select the VFP modeProgram Playback Repeat steps 2 to 4 to adjust other parametersRepeat to program the next steps To stop random playback Repeat PlaybackTrack Chapter Title A-B OFFTrack ALL/GROUP A-B OFF ChapterBasic Operations MP3 Disc PlaybackPress Repeat Operations through the MP3 Control ScreenOperations Stopping slide-show playback temporarily Jpeg Disc PlaybackSlide-show Playback Starting slide-show playbackRepeat Group Repeat ALL Operations through the Jpeg Control ScreenEnter Configuration of Choice menuChoice Menu Operations ChoicePress cursor ∞ or 5 repeatedly to move to Picture Source Press Enter to finish the settingPress Choice Press cursor 3 or 2 repeatedly to display Picture menuVideo Normal Picture setting menu-PICTUREChoice Menu Operations Language selection menu-LANGUAGEAudio selection menu-AUDIO Language code listYou can activate or deactivate the screen saver function Small Speaker setting menu-SPK. SettingFront SPEAKER, Center SPEAKER, LargeTime, the unit is turned off automatically Other setting menu-OTHERSWhen the playback of the disc on the built-in DVD player This function takes effect only when DVD is selectedParental Lock submenu appears on the TV Pop-up window for setting the country code appearsPop-up window for setting level appears See Country/Area codes list for Parental Lock onReleasing Parental Lock temporarily New setting is storedCountry/Area codes list for Parental Lock Glossary for DVD Player Connections 2 Video Cable Connection AV Compu Link Remote Control SystemTV’s Video Input 1 terminal using S-video cables Connections 1 AV Compu Link ConnectionOne-touch DVD play Automatic selection of TV’s input modeRemote control of the TV and VCR using this remote control Automatic power on/offOperating Audio Components Operating JVC’s Audio/Video ComponentsSound control section Amplifier Tuner FM ModeOperating Video Components CD recorderTry to operate your TV by pressing TV Changing the Preset Signal CodesOperating Other Manufacturers’ Equipment Release TVTurns on or off the DBS tuner Release DBSTry to operate your DBS tuner by pressing DBS You can always perform the following operationManufactures’ codes for VCR Manufacturer Codes Operating Other Manufacturers’ EquipmentRelease VCR Try to operate your VCR by pressing VCRHandling Discs MaintenanceGeneral Notes Cleaning Discs Cleaning the UnitProblem Possible Cause Solution TroubleshootingGeneral For DVD Player For Jpeg TroubleshootingFor Tuner For MP3General SpecificationsFM tuner IHF AM tunerPrecaução para a ligação à tensão da rede CA Precaución para la línea de la red CA
Top Page Image Contents