JVC VR 601 instruction manual Basic Connection, Connectiong to the AC Adapter, Memo

3. INSTALLATION

Please follow the instructions and the diagram below to set up the system.

3.1 Basic Connection

CONNECTIONG TO THE AC ADAPTER

Connect the provided AC adapter to the main unit.

			SD Card
	FROM MUX
VIDEO	MAIN MONITOR
		AUDIO	RS-485
	IN	IN
		ETHERNET	RS-232
		10/100
		OUT
	OUT
TO	TO		ALARM	I/O	DC12V
MUX'S VCR IN	MONITOR

Screw Clamp

AC	DC IN terminal
	DC cord

Provided AC

mains cable Provided AC adapter (model:STD-1205)

1.Connect the DC cord of the AC adapter to the DC IN terminal of the main unit.

2.To prevent accidental disconnection of the DC cord, fasten the DC cord with a wire catch.

1)Remove 1 screw followed by the wire catch.

2)Insert the DC cord into the wire catch and fasten the wire catch unto the main unit.

3.Connect the provided power cord to the AC IN terminal of the AC adapter.

4.Connect the power cord to the power socket.

•Power is channeled into the unit and the OPERATE indicator lights up green. (OPERATE ON mode)

•Press OPERATE button for at least 3 seconds to power off and the OPERATE indicator lights up orange.. (OPERATE OFF mode)

The orange light signals the hard-disk drive is power stand by.

Memo

•Even in the OPERATE OFF mode, a small amount of electricity will still flow into the unit.

•When the unit is in the OPERATE OFF mode, no operation can be performed except that of the OPERATE button.

Note:

•Please supply power to the unit via the provided AC adapter. Do not use other power sources.

•During recording or playback, please do not unplug the DC or power cord.

*About the location of the buttons, please refer to Page 10 2.1 Front View.

15