JVC VR 601 instruction manual Configuring Recording Settings, Best, High, Standard, Basic

Page 22

4. BASIC OPERATIONS

This section shows you how to operate and manage the DVR when it gets in the way.

4.1 Configuring Recording Settings

Recording Time settings (Recording Rate and Picture Quality Setting)

Recording time will vary depending on the image size, recording rate, and the capacity of the hard-disk drives. Generally, the DVR comes with a built-in hard-disk drive for continuous recording from one to four weeks under most recording conditions. The table below shows the possible recording times based on a 80GB hard-disk drive at certain refresh rates and the corresponding image quality. With one or more hard-disk drive(s) in operation, please calculate the recording time using the table below in accordance with your requirement. For a NTSC unit, for example, if the unit is set to record images with BEST quality at a 60 fps record rate, normally a 80GB hard-disk drive will be filled in 15 hours (See the gray area in the table). If the total capacity of 240GB hard-disk drives is in use under the same refresh rate and picture quality, it will be filled in 45 hours (3 times the rate of a 80GB hard-disk drive).

Set up the REC Time Mode when a multiplexer is connected

If a multiplexer is connected, for optimum image recording and playback, the record speed of the multiplexer must be correctly adjusted to match the DVR and set the MULTIPLEXER option on the setup menu to ON. This can be done by either of methods detailed below.

Connect the SW. OUT terminal in 9-PIN D-SUB connector on the rear panel of the DVR to the multiplexer’s trigger contact. The DVR will provide the timing signal (Negative/Falling) to the multiplexer. Thus, if the DVR changes the recording speed, the multiplexer will automatically adjust the record to match. A 2-hour and 4-hour timing signal in NTSC or a 3-hour and 6-hour one in PAL is constantly negative/falling.

NTSC (MUX ON)

 

 

 

 

 

 

 

 

 

 

 

Audio ON

 

 

Possible Recording Time HDD=80GB ( hour )

 

 

 

BEST

 

 

 

44.4

95.8

208.5

380.6

598.5

 

 

 

Image

HIGH

 

 

 

55.3

118.8

255.7

459.6

708.9

 

 

 

Quality

STANDARD

 

 

 

73.2

156.1

330.5

580.0

869.5

 

 

 

 

BASIC

 

 

 

108.4

227.6

467.3

785.9

1124.0

 

 

 

Refresh Rate (Field/Sec)

60

30

20

12

5.5

2.4

1.22

0.71

1/4

1/6

1/8

REC Time Mode

2 hr

4 hr

6 hr

12 hr

24 hr

48 hr

96 hr

168 hr

480 hr

720 hr

960 hr

22

Image 22
Contents Digital Video Recorder Important Safeguards Safety Precautions for USA and Canada AvertissementImportant In the United Kingdom Mains Supply AC 230 Power SystemFor Your Safety Australia Connection to the mains supplyPlace of storage and use About the provided power cables for VR-601 UHandling the unit Important Safety Instructions AC adapter sectionTable Of Contents Specifications Compatible Multiplexers Product Features Product IntroductionHard-disk compartment lock Front ViewHard-disk drive compartment Operate buttonOperate Indicator Rec IndicatorDisk Indicator Up / Down buttonsMobile Rack Power LED Mobile Rack HDD LEDRear View This Figure is Looked from the Rear Alarm In/OutNo Connection Connectiong to the AC Adapter Basic ConnectionMemo Connecting with a Single Camera Connecting with a MultiplexerConnecting with a Quad MultiplexerAttaching AN External Device to DVR Clock SETHard-Disk Drive Installation MaxtorQuality Best Ntsc Rate 6 HR System InformationMUX OFF Size POS Updating System Software High Configuring Recording SettingsBest StandardNtsc MUX OFF PAL MUX OFF Recording Operations Timer RecordingManual Recording Start END 0000-0000 M 0000-0000 W 0000-0000 0000-0000 0000-0000 0000-0000 0000-0000 0000-0000Externally triggered Recording Alarm RecordingPRE- Alarm OFF Main Alarm REC Enable REC Quality Best Audio OFF ALM Type ALM DurationDiagrams below Fast Forward/Reverse Operation Status From REC mode to Playback modePlayback Operations Search to play back a particular recorded videoSlow Forward/Reverse You can also operate by using button and buttonPlay Back Picture-by-picture Play Back Recorded Video from a HDD of the mobile rack Search Full List Alarm List Time Search Thumbnail SD CardSearch Operations Full List SearchTime Search Alarm list SearchAlarm List SearchSearch Thumbnail Year Full List Thumbnail Search2003 SD Card Search Backup Backup Main SET HD2 Usage Backup OperationsMobile Rack HD Backup Alarm Select Main Backup ALL to HD2Search button Alarm Select Main Backup Alarm to HD2Disk Setting Reformat HD2 Usage 1220 2001-02-01 0330 2001-03-02 0420 1330Save the whole setting into the SD card Security Digital Card SD Card BackupBackup the System setting info into SD Card Archive Single image Clips into SD CardTransfer the system setting info of DVR to another Key Lock OperationMenu Setup REC Setting REC QualityAlarm Setting REC Quality PRE- Alarm Timer Clock / TimerClock / Timer SET REC Enable OFF Main Timer REC Enable REC ScheduleNET Enable NET Enable OFF NET Dhcp NET IP SET FTP Setting MainCommunication REC Mode Alarm REC Comm Setting FTP Setting Comm IDEnable REC ModeUser PasswordFTP Account FTP IP PathBackup HD HD2 Usage Disk SettingBackup Full Main Disk REFORMAT/CLEAR BackupSystem Situation MAC 00 0c 0c 00 00 Bios SW 1.00J Date Jun 9 General Command Format SetupCommunication Protocol Value of a specific front panel key Request State Second Category=0x06 Request Time Second Category=0x02Set Time Second Category=0x02 Description of System StateMobile Rack Installation Jumper settings of hard-disk drives for the system LocationPage Push the active-handle inward Lock the Key System Default Disk Setting Reformat SET RS232 / RS485D Message Meanings Network Viewer PIN noPage View the VR-601 video from a remote PC Viewing images View all the connected devices Function Buttons DescriptionView single device Playback function bar Set the Alarm record settings Change the Record & Timer Properties Via the NetworkSet the regular record settings Set the record timerArchive Images to the Computer Image Viewer 12-02-02 01-30-03 Lists 2999 02-03-03 3000 02-08-03 Point stops recording Previously recorded data remainingConnect to a computer Physical specification of RJ-45 cable for EthernetCable Connections Connect to a LAN Hub IntranetEnable DVR Network Function RJ-45 PIN configuration for LAN HubConfigure Your DVR Network Settings Connect to WAN InternetEnable Dhcp Function Set IP Address12.3 TCP/IP Communication Software Page 12.5 TCP/IP Configuration setting 12.4 TCP/IP installationClick Start Settings Control Panel Network Connection Testing Click Start Programs MS-DOS PromptPage Design and specifications subject to change without notice Model Number VR-601 U VR-601 EDecode on Manufacturer Model ChannelColors DVR Viewer