JVC VR 601 instruction manual Safety Precautions for USA and Canada, Avertissement

Page 3

SAFETY PRECAUTIONS (FOR USA AND CANADA)

The lightening flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

Le symbole de l’ éclair a l’ interieur d’ un triangle equilateral est destine a alerter l’ utilisateur sur la presence d’ une tension dangereuse non isolee dans le boitier duprodult. Cette tension est sufflsante pour provoquer l’ electrocution de personnes

Le point d’ exclamation a l’linterieur d’ un triangle equilateral est destine a alerter l’ utilisateur sur la presence d’ openations d’ entretien importantes au sujet desquelles des renseignements se trouvent dand le manuel d’ instructions.

Ces symbols ne sont utilizes qu’aux Etats-Unis.

WARNING:

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

This unit should be used with 120V AC only.

CAUTION:

To prevent electric shocks and fire hazards, DO NOT use any other power.

NOTE:

The rating plate (serial number plate) is on the rear of the unit.

INFORMATION

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

CAUTION

CHANGES OR MODIFICATIONS NOT APPROVED BY JVC COULD VOID USER’S AUTHORITY TO OPERATE THE EQUIPMENT.

This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

CAUTION

Risk of explosion if replaced by an incorrect type. Dispose of used batteries according to the instructions.

.

AVERTISSEMENT:

POUR EVITER LES RISQUES D’INCENDIE OU D’ELECTROCUTION, NE PAS EXPOSER L’APPAREIL A L’HUMIDITE OU A LA PLUIE.

Ce magnetoscope ne doit etre utilize que sur du courant alternatif en 120V.

ATTENTION:

Afin d’eviter tout resque d’incendie ou d’electrocution, ne pas utiliser d’aufres sources d’alimentation electrique.

REMARQUE:

La plaque d’identification (numero de serie) se trouve dur le pammeau arriere de l’appareil.

WARNING:

The battery used in the VR-601U must be replaced by a JVC authorized service dealer only.

WARNING:

The installation of this equipment should be made by a qualified service person and should conform to all local codes.

Cet appareil numerique de la Classe A respecte toutes les exigencies du Reglement sur le materiel brouilleur du Canada.

3

Image 3
Contents Digital Video Recorder Important Safeguards Avertissement Safety Precautions for USA and CanadaConnection to the mains supply Power SystemFor Your Safety Australia Important In the United Kingdom Mains Supply AC 230About the provided power cables for VR-601 U Place of storage and useHandling the unit AC adapter section Important Safety InstructionsTable Of Contents Specifications Compatible Multiplexers Product Introduction Product FeaturesOperate button Front ViewHard-disk drive compartment Hard-disk compartment lockUp / Down buttons Rec IndicatorDisk Indicator Operate IndicatorMobile Rack HDD LED Mobile Rack Power LEDRear View Alarm In/Out This Figure is Looked from the RearNo Connection Basic Connection Connectiong to the AC AdapterMemo Connecting with a Multiplexer Connecting with a Single CameraMultiplexer Connecting with a QuadClock SET Attaching AN External Device to DVRMaxtor Hard-Disk Drive InstallationSystem Information Quality Best Ntsc Rate 6 HRMUX OFF Size POS Updating System Software Standard Configuring Recording SettingsBest HighNtsc MUX OFF PAL MUX OFF Timer Recording Recording OperationsManual Recording Start END 0000-0000 0000-0000 0000-0000 0000-0000 0000-0000 0000-0000 0000-0000 M 0000-0000 WREC Quality Best Audio OFF ALM Type ALM Duration Alarm RecordingPRE- Alarm OFF Main Alarm REC Enable Externally triggered RecordingDiagrams below Search to play back a particular recorded video Operation Status From REC mode to Playback modePlayback Operations Fast Forward/ReverseYou can also operate by using button and button Slow Forward/ReversePlay Back Picture-by-picture Full List Search Search Full List Alarm List Time Search Thumbnail SD CardSearch Operations Play Back Recorded Video from a HDD of the mobile rackSearch Alarm list SearchAlarm List Time SearchThumbnail Search Search Thumbnail Year Full List2003 SD Card Search Alarm Select Main Backup ALL to HD2 Backup OperationsMobile Rack HD Backup Backup Backup Main SET HD2 Usage1220 2001-02-01 0330 2001-03-02 0420 1330 Alarm Select Main Backup Alarm to HD2Disk Setting Reformat HD2 Usage Search buttonArchive Single image Clips into SD Card Security Digital Card SD Card BackupBackup the System setting info into SD Card Save the whole setting into the SD cardKey Lock Operation Transfer the system setting info of DVR to anotherMenu Setup REC Quality REC SettingAlarm Setting REC Quality PRE- Alarm REC Schedule Clock / TimerClock / Timer SET REC Enable OFF Main Timer REC Enable TimerNET Enable OFF NET Dhcp NET IP SET FTP Setting Main NET EnableCommunication REC Mode Comm Setting FTP Setting Comm IDEnable REC Mode Alarm RECPath PasswordFTP Account FTP IP UserBackup Disk SettingBackup Full Main Disk REFORMAT/CLEAR Backup HD HD2 UsageSystem Situation MAC 00 0c 0c 00 00 Bios SW 1.00J Date Jun 9 Setup General Command FormatCommunication Protocol Value of a specific front panel key Description of System State Request Time Second Category=0x02Set Time Second Category=0x02 Request State Second Category=0x06Jumper settings of hard-disk drives for the system Location Mobile Rack InstallationPage Push the active-handle inward Lock the Key System Default SET RS232 / RS485 Disk Setting ReformatD Message Meanings PIN no Network ViewerPage View the VR-601 video from a remote PC Function Buttons Description Viewing images View all the connected devicesView single device Playback function bar Set the record timer Change the Record & Timer Properties Via the NetworkSet the regular record settings Set the Alarm record settingsArchive Images to the Computer Image Viewer Point stops recording Previously recorded data remaining 12-02-02 01-30-03 Lists 2999 02-03-03 3000 02-08-03Connect to a LAN Hub Intranet Physical specification of RJ-45 cable for EthernetCable Connections Connect to a computerConnect to WAN Internet RJ-45 PIN configuration for LAN HubConfigure Your DVR Network Settings Enable DVR Network FunctionSet IP Address Enable Dhcp Function12.3 TCP/IP Communication Software Page 12.4 TCP/IP installation 12.5 TCP/IP Configuration settingClick Start Settings Control Panel Network Click Start Programs MS-DOS Prompt Connection TestingPage Model Number VR-601 U VR-601 E Design and specifications subject to change without noticeDVR Viewer Manufacturer Model ChannelColors Decode on