JVC VR 601 instruction manual

Page 57

5.Attach the interface connector and the power connector to the drive. Please note the red lining of the IDE cable and the red wire of power cable must line up side by side.

6.Place the hard-disk drive inside mobile rack, Use four of the provided screws.

7.Place the top cover back to the carrier body by sliding forward to secure.

8. Slide the carrier body back in the mobile rack.

9. Push the carrier body further into the mobile rack until fully inserted.

57

Image 57

Contents Digital Video Recorder Important Safeguards Avertissement Safety Precautions for USA and CanadaFor Your Safety Australia Power SystemImportant In the United Kingdom Mains Supply AC 230 Connection to the mains supplyAbout the provided power cables for VR-601 U Place of storage and useHandling the unit AC adapter section Important Safety InstructionsTable Of Contents Specifications Compatible Multiplexers Product Introduction Product FeaturesHard-disk drive compartment Front ViewHard-disk compartment lock Operate buttonDisk Indicator Rec IndicatorOperate Indicator Up / Down buttonsMobile Rack HDD LED Mobile Rack Power LEDRear View Alarm In/Out This Figure is Looked from the RearNo Connection Basic Connection Connectiong to the AC AdapterMemo Connecting with a Multiplexer Connecting with a Single CameraMultiplexer Connecting with a QuadClock SET Attaching AN External Device to DVRMaxtor Hard-Disk Drive InstallationSystem Information Quality Best Ntsc Rate 6 HRMUX OFF Size POS Updating System Software Best Configuring Recording SettingsHigh StandardNtsc MUX OFF PAL MUX OFF Timer Recording Recording OperationsManual Recording Start END 0000-0000 0000-0000 0000-0000 0000-0000 0000-0000 0000-0000 0000-0000 M 0000-0000 WPRE- Alarm OFF Main Alarm REC Enable Alarm RecordingExternally triggered Recording REC Quality Best Audio OFF ALM Type ALM DurationDiagrams below Playback Operations Operation Status From REC mode to Playback modeFast Forward/Reverse Search to play back a particular recorded videoYou can also operate by using button and button Slow Forward/ReversePlay Back Picture-by-picture Search Operations Search Full List Alarm List Time Search Thumbnail SD CardPlay Back Recorded Video from a HDD of the mobile rack Full List SearchAlarm List Alarm list SearchTime Search SearchThumbnail Search Search Thumbnail Year Full List2003 SD Card Search Mobile Rack HD Backup Backup OperationsBackup Backup Main SET HD2 Usage Alarm Select Main Backup ALL to HD2Disk Setting Reformat HD2 Usage Alarm Select Main Backup Alarm to HD2Search button 1220 2001-02-01 0330 2001-03-02 0420 1330Backup the System setting info into SD Card Security Digital Card SD Card BackupSave the whole setting into the SD card Archive Single image Clips into SD CardKey Lock Operation Transfer the system setting info of DVR to anotherMenu Setup REC Quality REC SettingAlarm Setting REC Quality PRE- Alarm Clock / Timer SET REC Enable OFF Main Timer REC Enable Clock / TimerTimer REC ScheduleNET Enable OFF NET Dhcp NET IP SET FTP Setting Main NET EnableCommunication Enable Comm Setting FTP Setting Comm IDREC Mode Alarm REC REC ModeFTP Account FTP IP PasswordUser PathBackup Full Main Disk REFORMAT/CLEAR Disk SettingBackup HD HD2 Usage BackupSystem Situation MAC 00 0c 0c 00 00 Bios SW 1.00J Date Jun 9 Setup General Command FormatCommunication Protocol Value of a specific front panel key Set Time Second Category=0x02 Request Time Second Category=0x02Request State Second Category=0x06 Description of System StateJumper settings of hard-disk drives for the system Location Mobile Rack InstallationPage Push the active-handle inward Lock the Key System Default SET RS232 / RS485 Disk Setting ReformatD Message Meanings PIN no Network ViewerPage View the VR-601 video from a remote PC Function Buttons Description Viewing images View all the connected devicesView single device Playback function bar Set the regular record settings Change the Record & Timer Properties Via the NetworkSet the Alarm record settings Set the record timerArchive Images to the Computer Image Viewer Point stops recording Previously recorded data remaining 12-02-02 01-30-03 Lists 2999 02-03-03 3000 02-08-03Cable Connections Physical specification of RJ-45 cable for EthernetConnect to a computer Connect to a LAN Hub IntranetConfigure Your DVR Network Settings RJ-45 PIN configuration for LAN HubEnable DVR Network Function Connect to WAN InternetSet IP Address Enable Dhcp Function12.3 TCP/IP Communication Software Page 12.4 TCP/IP installation 12.5 TCP/IP Configuration settingClick Start Settings Control Panel Network Click Start Programs MS-DOS Prompt Connection TestingPage Model Number VR-601 U VR-601 E Design and specifications subject to change without noticeColors Manufacturer Model ChannelDecode on DVR Viewer