JVC VR 601 instruction manual System Information, Quality Best Ntsc Rate 6 HR, MUX OFF Size POS

3.3 System Information

You can display system settings information as shown on Table 3.3 A below at any time by pressing the Display button . In the playback mode, the recorded video information is displayed. In the live or recording mode, the Manual Recording information is displayed. However, when the DVR is displaying a decoded image from a multiplexer, you must first switch the unit to encoded image displaying (The pictures is switching swiftly and the light of Monitor button is off) by pressing the Monitor button . Each sequential press of the Display button displays a different message detailed in the following example. By default, the unit displays time, date, and an indicating bar of capacity status on a monitor as shown next.

Default display		The TOP	Current	The END
		of the HDD	Position	of the HDD
(Capacity Used)	(Capacity Remaining)
09-05-2003	16:13:02
(Date)	(System Time)

Press the Display button once; the DVR will display the following sample message plus the default display. Press the Display button again; the unit will not display any OSD message. Press the button one more time to back to the default display.

Table 3.3 A.

1+ 2: 59G	12.4 HR
QUALITY: BEST	NTSC
RATE: 6 HR	20 F/S
MUX : OFF	9K

HD	P	SIZE	POS
1	Y	20 G	39.5% P
2	Y	39 G	0.0% R

IP : 192 . 168 . 1 . 90

Description of Table 3.3 A

(1+2: 59G): Total capacity of installed hard-disk, 59 GB

(12.4 HR): Total 12.4 hour recording time available

(	): Timer record activated
(	): Alarm record activated

(QUALITY: BEST): Record quality setting, BEST

(NTSC): NTSC system

(RATE: 6 HR): Setting of Record time mode, 6 hours

(20 F/S): Record speed setting, 20 fields/sec

(MUX: OFF): Only connected to a single camera.

(	): Audio function activated
(	): Indicate which HDD is activated
(9K): The image file size
(HD): Hard-disk Compartment
(P): Y Hard-disk installed; .		No hard-disk installed
(SIZE 20G): The capacity of the installed hard-disk
(POS): Percentage of system;		R: Recording; P: Playback
(IP : 192 . 168 . 1 . 90): Setting of the Ethernet
	communication,192.168.1.90
(	): External signal
( X): Cannot operate at now

*About the location of the buttons, please refer to Page 10 2.1 Front View.

20