DTS RV4700 DTS-ES manual When CD, Tape MON or Video 1~ Video 4 is selected

Page 16

When CD, TAPE MON or VIDEO 1~ VIDEO 4 is selected

4	Select the digital or the analog input
	connected as desired.

DIGITAL/ANALOG

•Each time this button is pressed, the corresponding input is selected as follows:

DIGITAL ANALOG

•To listen to DTS, Dolby Digital or MPEG program sources in the 2-CH downmix mode, in the stereo mode, the digital input should be selected. (For details, refer to “Downmixing into 2 front channels” on page 24.)

•When TUNER or AUX is selected as an input source, the analog input is automatically selected.

Notes:

•When the selected digital input is not connected. “DIGITAL” is flickering, meaning no sound. (Refer to “ENJOYING SURROUND SOUND” on page 21.)

•To select the digital input, you should match the connected DIGITAL IN to the corresponding input source.

(For details, refer to “When selecting the DIGITAL IN SETUP” on page 39.)

Operate the selected component for

5 playback.

•When playing back the program sources with surround sound, refer to “ENJOYING SURROUND SOUND” on page 21.

Adjust the (overall) volume.

6

MASTER VOLUME

VOL.

or

DOWNUP

Adjusting the tone (bass and treble)

Select the tone mode as desired.

7

TONE MODE

•Each time this button is pressed, the tone mode changes as follows:

BASS TREBLE DEFEAT OFF(or ON)

•The tone display is shown for 5 seconds.

•If the tone display disappears, press the TONE MODE button again.

•( ) : When the tone defeat function is activated (“DEFEAT ON”), bass and treble modes cannot be selected

Note:

•When the source direct function is activated, the tone mode cannot be selected.

At the desired tone mode, adjust as

8 desired.

MULTI CONTROL

At the tone defeat mode, each time the MULTI CONTROL knob is rotated, the tone defeat mode changes as follows:

DEFEAT ON : When listening to a program source without the tone effect.

DEFEAT OFF : When adjusting the tone for your taste.

At the desired tone (bass or treble), each time the MULTI CONTROL knob is rotated, the tone level can be adjusted within the range of +10~ -10 dB.

•In general, we recommend the bass and treble to be adjusted to 0(flat) level.

•To complete tone adjustment, repeat the above steps

and .

•Extreme settings at high volume may damage your speakers.

16

Image 16

Contents RV4700 DTS-ES Unpacking and Installation IntroductionRead this Before Operating Your Unit AC Voltage SelectionContents Connecting 7.1CH Direct INPUTs Connecting Antennas Connecting Audio ComponentsSystem Connections Connecting Video Components Front SUR Round BackConnecting Digital INs and OUT Connecting MULTI-ROOM System KITPRE OUT connections AC Inlet Connecting Speakers Switched AC OutletRoom 2 connections Front Panel Controls Fluorescent DisplayUniversal Remote Controls LED Lamp Device ButtonsFunction Table of the Numbered Buttons Remote Control Operation Range Loading BatteriesAdditional Information on Remote Command Codes Functions CodesEntering a Setup Code For Power ON/OFFWhen selecting the 7.1 CH Direct as desired OperationsBefore operation Tape Monitor functionWhen CD, Tape MON or Video 1~ Video 4 is selected Adjusting the tone bass and trebleSound tracks Surround Sound Surround modesTheater MovieHall 1/2 StadiumSpeaker placement Front left and right speakers and center speakerSurround left and right speakers Surround back left and right speakersSelected decoding mode as follows Enjoying Surround SoundWhen canceling the surround mode for normal stereo operation Adjusting each channel level Select the desired channelDownmixing into 2 front channels Auto tuning Manual tuningPresetting radio stations Listening to Radio BroadcastsTuning to preset stations Scanning preset stations in sequenceAdditional Function for RV4700 DTS-ES RDS Tuner Only Listening to RDS Broadcastsfm onlyEON PTY EON Enhanced Other Networks InformationDubbing the sound and image signals RecordingRecording with Tape Monitor Dubbing from video components ontoDigital Audio Recording with MD Recorder Operating the sleep timer Adjusting the brightness of the fluorescent displaysOther Functions Compressing the dynamic range Dolby Digital sources onlyEntering a video label Correcting or clearing a video labelRoom 2 Source Playback Using the OSD OSD Menu SettingsWhen selecting the desired input source Current Status DisplayWhen selecting the Speaker Setup When selecting the Surround SetupWhen selecting the Function Select When selecting the CH Level TrimSetting the Speaker Setup When selecting the Speaker ConfigWhen selecting the Speaker Distance When selecting the LFE Level Control When selecting the Input Setup Setting the Function SelectWhen selecting the Digital in Setup When selecting the Video Select When selecting the Tone Control When selecting the OSD Mode When selecting the Source Direct Setting the Surround SetupWhen selecting the Cinema EQ When selecting the Decoding Mode When selecting the surround modeSetting the CH Level Trim Setting the ROOM2 Feed Setup When selecting the Volume ModeWhen selecting the Function Select for Room When the Room 2 Feed mode is set to OnTroubleshooting Guide Problem Possible Cause RemedySpecifications RV4700 DTS-ES