DTS RV4700 DTS-ES manual Setting the CH Level Trim

Page 45

SETTING THE CH LEVEL TRIM

	C H L E V E L T R I M
F L	: ------	------	:	0	dB
C	: ------	------	:	0	dB
F R	: ------	------	:	0	dB
S R	: ------	------	:	0	dB
B R	: ------	------	:	0	dB
B L	: ------	------	:	0	dB
S L	: ------	------	:	0	dB
S W	: ------	------	:	0	dB
R E T U R N : B a c k		, : S e l e c t

Press the CURSOR UP( )/DOWN( ) buttons to select the desired channel.

1

• Each time these buttons are pressed, “ ” is moved to the corresponding channel.

Note :

• According to the speaker settings such as “None” and “No”, center, surround, surround back or subwoofer channel will not be selected.

Press the CURSOR LEFT( )/RIGHT( ) buttons to adjust the level of the selected channel as desired.

2

• Each time these buttons are pressed, the channel level can be adjusted within the range of -15~+15 dB.

3	Repeat the above steps	and	to adjust each channel level until the sound level of each speaker is
3	heard to be equally loud.

45

Image 45

Contents RV4700 DTS-ES Introduction Unpacking and InstallationAC Voltage Selection Read this Before Operating Your UnitContents Connecting Antennas Connecting Audio Components Connecting 7.1CH Direct INPUTsSystem Connections Front SUR Round Back Connecting Video ComponentsConnecting MULTI-ROOM System KIT Connecting Digital INs and OUTPRE OUT connections Switched AC Outlet AC Inlet Connecting SpeakersRoom 2 connections Fluorescent Display Front Panel ControlsLED Lamp Device Buttons Universal Remote ControlsFunction Table of the Numbered Buttons Loading Batteries Remote Control Operation RangeFunctions Codes Additional Information on Remote Command CodesFor Power ON/OFF Entering a Setup CodeOperations When selecting the 7.1 CH Direct as desiredBefore operation Tape Monitor functionAdjusting the tone bass and treble When CD, Tape MON or Video 1~ Video 4 is selectedSound tracks Surround modes Surround SoundMovie TheaterHall 1/2 StadiumFront left and right speakers and center speaker Speaker placementSurround left and right speakers Surround back left and right speakersEnjoying Surround Sound Selected decoding mode as followsWhen canceling the surround mode for normal stereo operation Select the desired channel Adjusting each channel levelDownmixing into 2 front channels Manual tuning Auto tuningPresetting radio stations Listening to Radio BroadcastsScanning preset stations in sequence Tuning to preset stationsListening to RDS Broadcastsfm only Additional Function for RV4700 DTS-ES RDS Tuner OnlyInformation EON PTY EON Enhanced Other NetworksRecording Dubbing the sound and image signalsRecording with Tape Monitor Dubbing from video components ontoDigital Audio Recording with MD Recorder Adjusting the brightness of the fluorescent displays Operating the sleep timerOther Functions Compressing the dynamic range Dolby Digital sources onlyCorrecting or clearing a video label Entering a video labelRoom 2 Source Playback OSD Menu Settings Using the OSDWhen selecting the desired input source Current Status DisplayWhen selecting the Surround Setup When selecting the Speaker SetupWhen selecting the Function Select When selecting the CH Level TrimWhen selecting the Speaker Config Setting the Speaker SetupWhen selecting the Speaker Distance When selecting the LFE Level Control Setting the Function Select When selecting the Input SetupWhen selecting the Digital in Setup When selecting the Video Select When selecting the Tone Control When selecting the OSD Mode Setting the Surround Setup When selecting the Source DirectWhen selecting the Cinema EQ When selecting the surround mode When selecting the Decoding ModeSetting the CH Level Trim When selecting the Volume Mode Setting the ROOM2 Feed SetupWhen the Room 2 Feed mode is set to On When selecting the Function Select for RoomProblem Possible Cause Remedy Troubleshooting GuideSpecifications RV4700 DTS-ES