DTS RV4700 DTS-ES manual Digital Audio Recording with MD Recorder

Start recording on the VIDEO 1.

3

Start play on the VIDEO 2 and the CD

4 respectively.

•The audio signal from the CD and the video signal from the VIDEO 2 will be dubbed and you can enjoy them on the TV set and from the speakers. Note: Be sure to observe the order of the above

steps and .

DIGITAL AUDIO RECORDING WITH MD RECORDER

•Only when the OPTICAL DIGITAL OUT of this receiver is connected to the OPTICAL DIGITAL IN of the MD recorder or CD recorder, you can enjoy high-quality sound of digital recording without converting the original signals. Refer to “CONNECTING AUDIO COMPONENTS” and “CONNECTING DIGITAL INs and OUT” on page 5 and 7 and the operating instructions of the MD recorder or CD recorder.

Notes:

•Digital recording is available for the digital audio program sources such as CDs, MDs, some DVDs, etc.

•In most DVDs as well as some CDs, etc., digital recording may not be available depending on the signal format.

•There are some restrictions on recording digital signals. When making digital recordings, refer to the operating instructions of your digital recording equipment to know what restrictions are imposed.

1	Select a desired input of CD, TAPE		2	For digital recording, select the desired
	MONITOR and VIDEO 1~VIDEO 4 as a			digital input as recording signal input.
	recording source.				DIGITAL/ANALOG
	INPUT SELECTOR
AUDIO	VIDEO TAPE MON.	VOL. CH LEVEL
	or		• Each time this button is pressed, the corresponding
	CD	T1/MON	input is selected as follows:
	VID1 VID2	HOME THEATER MASTER	DIGITAL		ANALOG
		VID3 VID4
		RV4700 DTS-ES
			Note: When the selected digital input is not
				connected, “DIGITAL” is flickering, meaning
				no recording as well as no sound.
3	Start recording on the component		4	Start play on the desired input.
	connected to OPTICAL DIGITAL OUT.

30