Toshiba 27AFX54 appendix To control a DVD player

Using the Remote Control

To control a DVD player:

	Power
Program the remote	Input (TV)
control to recognize the	Display
brand of your DVD
player (see	Number
“Programming the	buttons
remote control for use
with a cable TV	TOP Menu
converter/satellite
	Pic Size (TV)
receiver, VCR or DVD	DVD MENU
player” below). The	▲▼ ▼ ▼
buttons shown at right	ENTER
will then control the	TV • CBL/SAT • VCR
	• DVD selector
DVD player.
	Volume ▲▼ (TV)
Set the TV • CBL/SAT •	DVD Clear
VCR • DVD selector to	Mute (TV)
“DVD” first.	DVD controls

DVD Skip/Search /

Light

Programming the remote control for use with a cable TV converter/satellite receiver, VCR or DVD player

This remote control is pre-programmed to operate Toshiba satellite receivers, VCRs and DVD players. To control cable TV converters/ satellite receivers, VCRs and DVD players other than Toshiba models, you must follow the steps below to program your remote control.

1.Refer to the code tables (on pages 13 and 14) to find the corresponding code for your brand.

If more than one code is listed, try each one separately until you find the one that works.

2.If you are programming the remote control to operate your:

•Cable TV converter/satellite receiver: Set theTV • CBL/ SAT • VCR • DVD selector to “CBL/SAT.”

•VCR: Set the TV • CBL/SAT • VCR • DVD selector to “VCR.”

•DVD player: Set the TV • CBL/SAT • VCR • DVD selector to “DVD.”

3.While holding down RECALL, press the Channel Number buttons to enter the three-digit code for your cable TV converter/satellite receiver, VCR or DVD player brand.

4.Point the remote control at the cable TV converter/satellite receiver, VCR or DVD player, and press POWER to test the code.

•If the cable TV converter/satellite receiver, VCR or DVD player responds, you entered the correct code.

•If the cable TV converter/satellite receiver, VCR or DVD player does not respond, repeat steps 1–4 using another code.

5.Set the TV • CBL/SAT • VCR • DVD selector to “TV” to control the TV.

For future reference, write down the codes you used:

Cable TV converter/satellite receiver code _____________________

VCR code ______________________________________________

DVD player code _________________________________________

12

Recall

Channel

Numbers

TV • CBL/SAT

• VCR • DVD selector

Notes:

•When shipped from the factory, the remote control is set to operate your TV.

•If you do not enter the code within 10 seconds from step 1 or if you enter a code not listed below, this operation is canceled.

•Each time you replace the batteries, you must reprogram the remote control.

•Some newer VCRs are capable of working on either of two remote codes. These VCRs have a switch labeled “VCR1/VCR2.”

If your VCR has this kind of switch and does not respond to any of the codes for your VCR, set the switch to the other position (VCR1 or VCR2) and reprogram the remote control.

3N11601A/E P07-17 12 1/19/04, 6:01 PM