Files are listed on the screen as they are moved to the hard disk. When all copying has been completed, you are prompted to remove the disk.
N O T E :
If the package will not load because of a conflict error, verify that serial port 2 is disabled. You should have disabled this port when you installed the Integrated Voice Power system software. If this is the reason for the conflict, see DCP Conflict at the end of the chapter for instructions on disabling serial port 2.
If this problem persists, call the next tier of support for assistance.
4. After the installation has completed, remove the diskette.
5. If prompted for shutdown, press (Enter) to shut down the system. When you are prompted to reboot the system, press (Ctrl) + (Alt) + (Del) simultaneously.
3.
Depending on which telephone system you have, you maybe asked which version of the switch you are using.
If asked, indicate the version of the switch and press (Enter).
Software Installation
N O T E :
If the system configuration includes a tape drive or multiple floppy disk drives, additional prompts may appear. Use the preceding steps as a guide to responding to the system prompts. The actual prompts may vary depending on the system configuration.
2. Insert the Switch Integration Software disk into the floppy disk drive and press (Enter).