Upgrade Procedures
N O T E :
If the system configuration includes a tape drive or multiple floppy disk drives, additional prompts may appear. Use the preceding steps as a guide to responding to the system prompts. The actual prompts may vary depending on the system configuration.
b.Insert the Switch Integration software disk into the floppy disk drive and press (Enter).
Depending on which telephone system you have, you may be asked which version of the switch you are using.
c.If asked, indicate the version of the switch and press
(Enter).
Files are listed on the screen as they are moved to the hard disk. When all copying has been completed, you will be prompted to remove the disk.
NOTE:
If the package will not load because of a conflict error, verify that serial port 2 is disabled.
If this problem persists, call the next tier of support for assistance.
d.After the installation has completed, remove the disk.
e.If prompted for shutdown, press (Enter) to shut down the system. When you are prompted to reboot the system, press (Ctrl) + (Alt) + (Del) simultaneously.
10.Install the remote access software (if not already loaded). Follow the procedure in Installing Software for Remote Access in Chapter 3.