Hardware Installation
Connecting Voice and Data Lines
Voice lines must be connected to the IVP4 board(s) and a data line must be connected to the DCP board if it is used.
Connecting the IVP Voice Lines
Each IVP4 board has two
and 4.
If the line pairs are run two per jack (RJ14C), use two standard,
If the line pairs are run individually (RJ11 C), a type 884A adapter maybe used to consolidate the four individual line pairs into two pairs (RJ14C) in each of two cables.
CAUTION:
There is a magnet on the back of the 884A adapter. Be sure that you do not place this near the hard disk drive or floppy disks.