Hardware Installation
Diagnostics
The only diagnostics that can be run at this time are those provided on the Customer Test disk for testing the basic system integrity. Additional diagnostics for the IVP4 boards cannot be run until the software is installed.
To run the Customer Test diagnostics, follow these steps:
1.Insert the Customer Test disk supplied with the system into floppy disk drive A.
N O T E :
Be sure to shut down the UNIX system before rebooting.
2.Boot the system by turning power ON or by pressing (Reset) if the power is already on.
The system boots from the Customer Test disk and displays the Customer Test introduction screen.
3.Press (Enter) to continue.
—The Customer Test main menu appears.
4.Use to move the highlight bar to System Checkout or Test All Modules (the command displayed depends on the processor that you are using) and press (Enter).
N O T E :
If Test All Modules appears on the main menu, Customization Screen will also appear. On the Customization Screen the interactive mode must be set to on before you select Test All Modules if the speaker test, floppy disk drive test, keyboard keystrokes and typematic tests, and mouse tests are to be performed. If the interactive mode is off, these tests will not be performed.