Software Installation
Testing the IVP4 Switch Settings
After setting the switches on each board correctly, to verify the correctness of the switch settings, go to Step 4 of the Determining the IVP4 Board by Testing section in Chapter 2.
DCP Conflict
If your system includes a DCP board, you must disable serial port 2. There is a conflict between the DCP board and the hardware used for serial port 2. To disable serial port 2, follow these steps:
1.Log in as root (if not already logged in).
2.At the # prompt, type face and press (Enter). The AT&T FACE menu appears.
3.At the AT&T FACE menu, select System Administration and press (Enter).
The System Administration menu appears.
4.At the System Administration menu, select Peripherals Setup and press (Enter).
The Peripheral Setup menu appears.
5. At the Peripheral Setup menu, select Enable/Disable Second Serial Port and press (Enter).
The Enable/Disable Second Serial Port menu appears.
6.At the Enable/Disable Second Serial Port menu, select Disable Second Serial Port and press (Enter).
The second serial port is disabled.
The system will show a confirmation screen telling you to reboot the system as soon as possible.
7.Press [F3] (CONT).
8.When prompted for a shutdown, press (Enter) to shut down the system.
9.When prompted to reboot, press (Ctrl) + (Alt) + (Del) simultaneously.