AT&T 2.1.1 manual Installing Software for Remote Access, Press F2 CHOICES. Continue pressing

Software Installation

Installing Software for Remote Access

Remote access for administration can be provided over dial-up lines.

Use the following procedures to install software to drive the modem.

1.Log in as root (if you are not already logged in).

2.At the # prompt, type face and press (Enter).

3.Move the cursor to System Administration and press (Enter).

4.Move the cursor to Peripheral Setup and press (Enter).

5.Move the cursor to Serial Port Setup and press (Enter).

6.Populate the fields as follows:

■ Serial Port Number: 01 (/dev/tty00)

■Device Type: Modem

■Device Speed: 2400

7.Press [F3] (SAVE).

Another form appears. Populate the fields as follows:

■Modem Name:

Press [F2] (CHOICES). Select the modem type that you are installing. (The selection Hayes Smartm 2400 should be used for most 2400-baud modems. Hayes Smartm 1200 will usually work for lower-speed modems.)

■Device Connection:

Press [F2] (CHOICES). Continue pressing

[F2] (CHOICES) until the field reads Both Incoming and Outgoing calls.

8.Press [F3] (SAVE).

9.Press [F3] (CONT).

10.Use [F6] (CANCEL) to exit FACE back to the main menu.

3-37