AT&T 2.1.1 manual Opening the 6386/SX WGS, SX WGS Main Cover-Securing Screws

Hardware Installation

Opening the 6386/SX WGS

Follow these steps to remove the cover:

1.Be sure the system power is turned OFF. If any cables have been connected to the system module, disconnect them.

2.Unlock the cover lock. (A set of keys is packed in a plastic bag in the carton with the system module.)

3.Loosen the three main cover-securing screws (A, B, and C) on the back panel as shown in Figure 2-4.

A B c

o

Figure 2-4. 6386/SX WGS Main Cover-Securing Screws

4.Slide the cover off the system module by pulling it forward until it clears the back half of the chassis. Then tilt the back of the cover up and remove it. Take care not to catch the cover on any internal cables or wires.

2-9