Sterling BF3-600 specifications Cleaning the DT Dosing Station

Page 41

9.Install the dosing container along with the dosing hopper on the dosing housing (pay attention to the guide pins).

10.Mount the profile clamp.

11.Mount the screw at the profile clamp.

5.6Cleaning the DT Dosing Station

1.Empty the dosing station.

2.Switch the control unit off by means of the on/off switch.

3.Disconnect from mains voltage.

4.Open the profile clamp (C) of the dosing container.

5.Remove the profile clamp (C).

6.Remove the dosing container (B) along with the dosing hopper (A).

7.Open the safety screws at the toggle-type fasteners.

8.Open the toggle-type fasteners.

9.Remove the dosing housing (D) from the mixing hopper.

10.Clean the dosing housing (D) with a paintbrush.

11.Clean the dosing container (B) and the dosing hopper (A) in soapy water.

12.Dry all parts thoroughly.

13.Mount the dosing housing onto the dosing motor.

14.Observe that the guide pins are locked into position.

15.Close the toggle-type fasteners.

16.Mount the safety screws.

Digital Dosing Units

40

Image 41

Contents SDD Digital Dosing Units Parts and Service Department Table of Contents Station Digital Dosing Unit IntroductionI C K A R T G E S V E U E R D E R Touch Keypad ControllerKeys and Symbols Symbols Quick Start-up Recipe Setup For Injection MoldingUnpacking MountingCalibration Recipe Setup For ExtrusionI C K A R T G E S V E U E R D E R Initial Installation Initial Installation And OperationElectrical Diagram Electrical diagram of connectionsInitial Operation Diagram of frequency inputsStep Injection MoldingRecipe Input Injection Molding Step Step Step Operation-Injection Molding Recipe Input Extrusion Constant Extrusion ConstantStep Step Operation -Extrusion Constant Recipe Input Extrusion Proportional Extrusion ProportionalStep Operation -Extrusion Proportional Calibration Determining the Calibration Weight Repeat steps 3 and 4 four 4 more times Digital Dosing Units Recipe Storage Advanced Operations/ Control FunctionsRecipe Storage And Recall Recipe Recall Optional Equipment Acknowledging AlarmsClearing The Totalizer Level Probes AlarmsEuromap E17 Interface MixerMaintenance Intervals MaintenanceRemoving the Scraper Removing the scraperDismantling the Dosing Station Cleaning the Digital Dosing Dosing StationInstalling the scraper Installing the Dosing Station Removing the Dosing Disc Installing the Dosing DiscRemoving/Replacing the Scraper in the DT Dosing Station Installing Different Types of Dosing DiscsCleaning the DT Dosing Station Replacing Fuses Exchangeable StationsSee Appendix D on page 61 for fuse part numbers Malfunctions or Errors Error Codes Appendix a TroubleshootingGeneral Troubleshooting Unit Will Not Operate Error Codes Recipe Formulas Determining the Software Setup FactorInjection Molding ExtrusionRecipe Limitations Extrusion Max. input frequency = Hz Appendix B Basic Parameter SettingsExtrusion Mode Extrusion Constant or Proportional Determining the Configuration ValueProbe Digital Dosing Units Basic Parameter Settings Digital Dosing Units Digital Dosing Units Disc Dosing Factor Disc Guide D30-051725 DT30-102025 DP30 Disc Dosing Factor Table Specification SheetDigital Dosing unit parameter setup Page Station 1 Digital Dosing Unit Side View TOP View Station 2 Digital Dosing UnitDosing Unit Electrical Schematic Chart Dosing Disc/Shear Order Numbers Appendix D Spare Parts ListPage Technical Assistance Service DepartmentParts Department Sales Department