Sterling BF3-600 specifications Operation-Injection Molding

Page 19

1.Pressing again will first display the number “18” and then will display the total throughput in kilograms (totalizer).

Operation-Injection Molding

1.Ensure that the unit is properly installed (Section 3.1), a recipe is entered (section 3.3.1), and the feeder is calibrated (Section 3.6), before attempting to begin operation.

2.If desired, clear the totalizer by holding the Stop key () continuously for five seconds until the display is reset to “00.00.”

3.Place the Digital Dosing feeder into operation by pressing the Run key (). The green LED will light when the unit is ready to dose.

or

Start the molding machine. The Digital Dosing feeder will not dose material until the molding

machine screw recovers. If the unit is installed properly, the process machine symbol will

Digital Dosing Units

18

Image 19
Contents SDD Digital Dosing Units Parts and Service Department Table of Contents Station Digital Dosing Unit IntroductionI C K A R T G E S V E U E R D E R Touch Keypad ControllerKeys and Symbols Symbols Mounting Recipe Setup For Injection MoldingQuick Start-up UnpackingCalibration Recipe Setup For ExtrusionI C K A R T G E S V E U E R D E R Initial Installation Initial Installation And OperationElectrical Diagram Electrical diagram of connectionsInitial Operation Diagram of frequency inputsRecipe Input Injection Molding Injection MoldingStep Step Step Step Operation-Injection Molding Recipe Input Extrusion Constant Extrusion ConstantStep Step Operation -Extrusion Constant Recipe Input Extrusion Proportional Extrusion ProportionalStep Operation -Extrusion Proportional Calibration Determining the Calibration Weight Repeat steps 3 and 4 four 4 more times Digital Dosing Units Recipe Storage And Recall Advanced Operations/ Control FunctionsRecipe Storage Recipe Recall Clearing The Totalizer Acknowledging AlarmsOptional Equipment Level Probes AlarmsEuromap E17 Interface MixerRemoving the scraper MaintenanceMaintenance Intervals Removing the ScraperInstalling the scraper Cleaning the Digital Dosing Dosing StationDismantling the Dosing Station Installing the Dosing Station Removing the Dosing Disc Installing the Dosing DiscRemoving/Replacing the Scraper in the DT Dosing Station Installing Different Types of Dosing DiscsCleaning the DT Dosing Station Replacing Fuses Exchangeable StationsSee Appendix D on page 61 for fuse part numbers General Troubleshooting Unit Will Not Operate Appendix a TroubleshootingMalfunctions or Errors Error Codes Error Codes Extrusion Determining the Software Setup FactorRecipe Formulas Injection MoldingRecipe Limitations Extrusion Extrusion Mode Appendix B Basic Parameter SettingsMax. input frequency = Hz Extrusion Constant or Proportional Determining the Configuration ValueProbe Digital Dosing Units Basic Parameter Settings Digital Dosing Units Digital Dosing Units Disc Dosing Factor Disc Guide D30-051725 DT30-102025 DP30 Disc Dosing Factor Table Specification SheetDigital Dosing unit parameter setup Page Station 1 Digital Dosing Unit Side View TOP View Station 2 Digital Dosing UnitDosing Unit Electrical Schematic Chart Dosing Disc/Shear Order Numbers Appendix D Spare Parts ListPage Sales Department Service DepartmentTechnical Assistance Parts Department