Sterling BF3-600 specifications Clearing The Totalizer, Acknowledging Alarms, Optional Equipment

Page 33

Press and hold until the totalizer appears on the screen.

The recipe is now active and can be run or edited.

NOTE: The recalled recipe now becomes the active recipe.

4.2Clearing The Totalizer

The totalizer displays the total amount of additive dosed since the last time the totalizer was cleared.

The totalizer can be cleared by pressing Stop continuously for 5 seconds until the display is reset to “00.00.” The totalizer can be configured to read throughput in grams or pounds.

See Appendix A to learn how to change the unit of measure.

4.3Acknowledging Alarms

When an alarm occurs, the Alarm symbol flashes red and the dosing process stops.

If the Digital Dosing is equipped with an audible alarm or flashing light, it will also be activated.

Alarms are acknowledged by pressing .

The alarm will also initiate an error code.

See Appendix A for Troubleshooting suggestions for various alarms.

The alarm condition must be corrected prior to beginning operation again.

4.4Optional Equipment

Optional equipment for the Digital Dosing Additive Feeder includes:

Digital Dosing Units

32

Image 33
Contents SDD Digital Dosing Units Parts and Service Department Table of Contents Station Digital Dosing Unit IntroductionI C K A R T G E S V E U E R D E R Touch Keypad ControllerKeys and Symbols Symbols Quick Start-up Recipe Setup For Injection MoldingUnpacking MountingCalibration Recipe Setup For ExtrusionI C K A R T G E S V E U E R D E R Initial Installation Initial Installation And OperationElectrical Diagram Electrical diagram of connectionsInitial Operation Diagram of frequency inputsInjection Molding Recipe Input Injection MoldingStep Step Step Step Operation-Injection Molding Recipe Input Extrusion Constant Extrusion ConstantStep Step Operation -Extrusion Constant Recipe Input Extrusion Proportional Extrusion ProportionalStep Operation -Extrusion Proportional Calibration Determining the Calibration Weight Repeat steps 3 and 4 four 4 more times Digital Dosing Units Advanced Operations/ Control Functions Recipe Storage And RecallRecipe Storage Recipe Recall Acknowledging Alarms Clearing The TotalizerOptional Equipment Level Probes AlarmsEuromap E17 Interface MixerMaintenance Intervals MaintenanceRemoving the Scraper Removing the scraperCleaning the Digital Dosing Dosing Station Installing the scraperDismantling the Dosing Station Installing the Dosing Station Removing the Dosing Disc Installing the Dosing DiscRemoving/Replacing the Scraper in the DT Dosing Station Installing Different Types of Dosing DiscsCleaning the DT Dosing Station Replacing Fuses Exchangeable StationsSee Appendix D on page 61 for fuse part numbers Appendix a Troubleshooting General Troubleshooting Unit Will Not OperateMalfunctions or Errors Error Codes Error Codes Recipe Formulas Determining the Software Setup FactorInjection Molding ExtrusionRecipe Limitations Extrusion Appendix B Basic Parameter Settings Extrusion ModeMax. input frequency = Hz Extrusion Constant or Proportional Determining the Configuration ValueProbe Digital Dosing Units Basic Parameter Settings Digital Dosing Units Digital Dosing Units Disc Dosing Factor Disc Guide D30-051725 DT30-102025 DP30 Disc Dosing Factor Table Specification SheetDigital Dosing unit parameter setup Page Station 1 Digital Dosing Unit Side View TOP View Station 2 Digital Dosing UnitDosing Unit Electrical Schematic Chart Dosing Disc/Shear Order Numbers Appendix D Spare Parts ListPage Technical Assistance Service DepartmentParts Department Sales Department