Sterling BF3-600 specifications Step

Page 21

Press once.

The symbol will flash.

After “1” flashes on the screen, a number in the format xxx.xx will come up on the display.

Enter the additive percentage by using the Arrow Keys . The range of values that can be entered is 0.01 to 50.00%. The arrow keys are used to change all process variables. The double arrow key allows the user to ramp up or down at a faster rate.

Step 2:

or

Press again.

The symbols “g,” or “lb”, “min”, and flash.

After “2” flashes quickly on the display, a number in the format xxx.xx will come up on the display.

Enter the total extruder throughput in grams per minute or pounds per minute. The range of values that can be entered is 001.0 to 6500 grams per minute (00.01 to 14.30 lb/m).

Step 3:

or

Digital Dosing Units

20

Image 21
Contents SDD Digital Dosing Units Parts and Service Department Table of Contents Station Digital Dosing Unit IntroductionI C K A R T G E S V E U E R D E R Touch Keypad ControllerKeys and Symbols Symbols Quick Start-up Recipe Setup For Injection MoldingUnpacking MountingCalibration Recipe Setup For ExtrusionI C K A R T G E S V E U E R D E R Initial Installation Initial Installation And OperationElectrical Diagram Electrical diagram of connectionsInitial Operation Diagram of frequency inputsInjection Molding Recipe Input Injection MoldingStep Step Step Step Operation-Injection Molding Recipe Input Extrusion Constant Extrusion ConstantStep Step Operation -Extrusion Constant Recipe Input Extrusion Proportional Extrusion ProportionalStep Operation -Extrusion Proportional Calibration Determining the Calibration Weight Repeat steps 3 and 4 four 4 more times Digital Dosing Units Advanced Operations/ Control Functions Recipe Storage And RecallRecipe Storage Recipe Recall Acknowledging Alarms Clearing The TotalizerOptional Equipment Level Probes AlarmsEuromap E17 Interface MixerMaintenance Intervals MaintenanceRemoving the Scraper Removing the scraperCleaning the Digital Dosing Dosing Station Installing the scraperDismantling the Dosing Station Installing the Dosing Station Removing the Dosing Disc Installing the Dosing DiscRemoving/Replacing the Scraper in the DT Dosing Station Installing Different Types of Dosing DiscsCleaning the DT Dosing Station Replacing Fuses Exchangeable StationsSee Appendix D on page 61 for fuse part numbers Appendix a Troubleshooting General Troubleshooting Unit Will Not OperateMalfunctions or Errors Error Codes Error Codes Recipe Formulas Determining the Software Setup FactorInjection Molding ExtrusionRecipe Limitations Extrusion Appendix B Basic Parameter Settings Extrusion ModeMax. input frequency = Hz Extrusion Constant or Proportional Determining the Configuration ValueProbe Digital Dosing Units Basic Parameter Settings Digital Dosing Units Digital Dosing Units Disc Dosing Factor Disc Guide D30-051725 DT30-102025 DP30 Disc Dosing Factor Table Specification SheetDigital Dosing unit parameter setup Page Station 1 Digital Dosing Unit Side View TOP View Station 2 Digital Dosing UnitDosing Unit Electrical Schematic Chart Dosing Disc/Shear Order Numbers Appendix D Spare Parts ListPage Technical Assistance Service DepartmentParts Department Sales Department