5 Commissioning | LXM32M |
|
|
5.7Setting I/O-Scanning
5.7.1Activating I/O scanning
I/O scanning is activated/deactivated by means of the parameter
EthMbScanner.
▶If you do not want to use I/O scanning, set the parameter
EthMbScanner to "Off".
Parameter name | Description | Unit | Data type | Parameter address |
HMI menu |
| Minimum value | R/W | via fieldbus |
HMI name |
| Factory setting | Persistent |
|
|
| Maximum value | Expert |
|
|
|
|
|
|
EthMbScanner | Modbus TCP I/O scanning | - | UINT16 | CANopen 3044:28h |
| 0 / Off: Modbus TCP I/O scanning off | 0 | UINT16 | Modbus 17488 |
| 1 | UINT16 | Profibus 17488 | |
| 1 / On: Modbus TCP I/O scanning on | |||
| 1 | UINT16 | CIP 168.1.40 | |
|
| |||
| I/O scanning only works if the parameter |
| R/W |
|
| EthMode is set to Modbus TCP. |
| per. |
|
| Changed settings become active immedi- |
| - |
|
|
|
|
| |
| ately. |
|
|
|
|
|
|
|
|
5.7.2Setting the master for I/O scanning
Entering the IP address of a master reserves I/O scanning for this master. This means that no other master on the network can perform I/O scanning.
WARNING
UNINTENDED EQUIPMENT OPERATION DUE TO UNLIMITED ACCESS
If the IP addresses are not set correctly, any network device may control the system or access by the master may be blocked.
•Verify that you have set the correct master IP address.
Failure to follow these instructions can result in death, serious injury or equipment damage.
The IP address of the master for I/O scanning is set by means of the parameters EthIPmaster1 ... EthIPmaster4.
▶Set the IP address of the master for I/O scanning with the parame- ters EthIPmaster1 ... EthIPmaster4.
0198441113843, V1.01, 01.2012
46 |