
LOW LIGHT SHARPNESS
(Applies to 27X and 35X models only.)
Low light sharpness allows you to control the video sharpness in
NOTE: Changing the low light sharpness causes the camera to reset, which resets all camera settings to their factory defaults.
MINIMUM FOCUS DISTANCE
(Applies to 27X and 35X models only.)
Minimum focus distance improves focus capability in
30 CM (default): Improves focus for scenes in which the camera is typically focusing on objects at close range (less than 3 meters).
3 M: Improves focus for scenes in which the camera is typically focusing on objects at a distance of 3 meters or more.
MOTION SETTINGS
SPECTRA IV
LANGUAGE
<SYSTEM INFORMATION> <DISPLAY SETUP> <DOME SETTINGS> ACK ALERT*
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
EXIT
DOME SETTINGS
<CAMERA>
<MOTION>
<AUTO TRACKING> <POWER UP> <LINE SYNC> <PRESETS> <PATTERNS> <ZONES>
<WINDOW BLANKING> <ALARMS>
<AUX>
<TITLE TEXT> <ALERT>* <CLEAR> <PASSWORD> <CLOCK> <EVENT>
BACK
EXIT
MOTION
AUTO FLIP PROPORTIONAL PAN PARK TIME (MINUTES)
PARK ACTION SCAN SPEED (DEG/S) PRESET FREEZE FRAME
LIMIT STOPS
<SET MANUAL STOPS>
<CLEAR MANUAL STOPS> <SET SCAN STOPS> <CLEAR SCAN STOPS>
<SET AZIMUTH ZERO>
<CLEAR AZIMUTH ZERO>
BACK
EXIT
REFERENCE INFORMATION MANUAL LIMITS SET SCAN LIMITS SET
AUTO FLIP
When the camera tilts downward and goes just beyond the vertical position, the dome rotates 180 degrees. When the dome rotates (flips), the camera starts moving upward as long as you continue to hold the joystick in the down position. Once you let go of the joystick after the dome rotates, joystick control returns to normal operation. The
There are two auto flip modes:
ON (default): Auto flip mode is enabled.
OFF: Auto flip mode is disabled.
PROPORTIONAL PAN
Proportional pan automatically reduces or increases the pan and tilt speeds in proportion to the amount of zoom. At telephoto zoom settings, the pan and tilt speeds will be slower for a given amount of joystick deflection than at wide zoom settings. This keeps the image from moving too fast on the monitor when there is a large amount of zoom.
There are three proportional pan modes:
ON (default): Enables the proportional pan mode.
OFF: Disables proportional pan mode. The pan speed will not depend on the amount of zoom.
2X: Increases the speed of the proportional pan mode to twice that used when proportional pan is set to ON.
*This setting applies to Pressurized Spectra IV dome systems only.
29 |