The right sequence to connect and set the camera
Follow the procedures below to connect/set this unit.
Turn off the power of devices to be used before connecting the cables.
Before touching the camera unit, make sure to touch the metal surface of the [MONITOR] terminal to discharge any static electricity from your body. Static electricity may cause the camera to malfunction.
When mounting the base to the ceiling, or when connecting the cable of the camera unit, pay enough attention to the fall of each part.
When mounting the heater (sold separately:
| Set the switches | ||
step 1 | (A Pg. 20) | ||
Remove the dome cover, followed | |||
| by setting the video image | ||
| switches. | ||
K |
|
| |
|
|
| |
| Mounting the base | ||
step 2 | (A Pg. 21) | ||
Mount the base to the wall or | |||
| |||
| ceiling. | ||
K |
|
| |
|
|
| |
| Connect the cable | ||
step 3 | (A Pg. 22) | ||
Connect the coaxial cable and | |||
| |||
| power supply for the heater. | ||
K |
|
| |
|
|
| |
| Mounting the camera unit |
| |
| (A Pg. 23) |
| |
step 4 | Fill the piping hole and screw hole |
| |
| with a sealing material, followed |
| |
| by mounting the camera unit to |
| |
| the base. |
| |
K |
|
| |
|
|
| |
| Adjusting the video image | ||
step 5 | (A Pg. 25) | ||
Adjust the camera’s angle, focus | |||
| |||
| and brightness. | ||
K |
|
| |
|
|
| |
| Mounting the inner dome | ||
step 6 | (A Pg. 30) | ||
After setting is complete, mount | |||
| |||
| the inner dome to the camera. | ||
K |
|
| |
|
|
| |
| Mounting the dome cover |
| |
| (A Pg. 30) |
| |
step 7 | Insert the silica gel into the |
| |
designated space to prevent |
| ||
| fogging of the dome cover, |
| |
| followed by mounting the dome |
| |
| cover. |
| |
|
|
| |
19