JVC TK-C215VP4U/E, TK-C215VP12U/E manual Dimensional Outline Drawing

Page 38

Others

Specifications (continued)

Dimensional Outline Drawing

[Unit: mm (inch)]

121(4-3/4)

113(4-1/2)


		/4
	1
-
160(6

5(1/4)

9

(3/8)

42(1-5/8)

G3/4-14 UNC screw for piping (bottom surface, side surface)

SR5 (2 - 3 1/8). 7

125(4-7/8)

160(6-1/4)

*Specifications and appearance of this unit and related products are subject to change for product improvement without prior notice.

38

Image 38

Contents TK-C215VP4U/E Instructions TK-C215VP12U/E For Customer UseIntroduction Safety Precautions For USA and CanadaDear Customer Characteristics Table of Contents Others Precautions for proper use of this productStorage and Location of Use Note on consumable parts MaintenanceEnergy Conservation TK-C215VP12U/E onlyName of Parts CameraVideo signal output connector BNC AC 24 V/DC 12 V Power Supply WireAlarm signal cable TK-C215VP12U/E only BaseCamera Interior MemoB,+/- R/B,+/- adjustment button Setting the Switches Lens TK-C215VP4U/ERESET/SPOT RESET/SPOT button Function selection switches AGC Auto-gain control switchBLC Backlight compensation switch Sync Synchronization system selection switchWHT.BAL. ATW/MANUAL selection switch DAY/NIGHT Easy Day & Night switchPosition Select Position Select button Alarm Position status indication LEDB,+/- R/B, +/- adjustment button Alarm alarm input mode selection switch TriggerSystem Example Metal ContactAbout Connection Cables Video signal cablesDC 12 V or AC 24 V power supply cable Electrical Specifications of Alarm Input Terminals ‹ Polarity of alarm signalsRight sequence to connect and set the camera Removing the dome cover Setting the switchesSetting the switches Removing the inner domeMounting the base SetupMounting the fall prevention wire to a firm place Removing the camera unit from the baseConnect the alarm cable. TK-C215VP12U/E onlyA Pg Connecting the coaxial cable a PgConnecting the AC 24 V/DC 12 V power supply wires Cable ConnectionMounting the camera unit to the base Mounting the camera unitFill the hole with sealing material Fastening the 2 fastening screws of the camera unitInserting the silica gel supplied Mounting the test monitor Adjusting the video imageAdjusting the shooting direction of the camera Adjusting the focus Adjusting the angle of view, focus and brightnessAdjusting the angle of view TK-C215VP4U/EAdjusting the brightness TK-C215VP12U/E Adjust the focusAdjust the brightness Registering home position Registering alarm position Mounting the inner dome Mounting the dome coverMounting the camera using the electrical box Following procedures are same as normal mountingMounting the base to the pipe Mounting the camera using the pipeMounting the fall prevention wire to a firm place a Pg Fastening the base to the ceilingRemoving the plug for the piping hole of the base White-spot correction Page Specifications Camera Lens General Dimensional Outline Drawing Focus chart TK-C215VP4U/E TK-C215VP12U/E Dome Camera