Installation and Connection
Mounting the camera using the pipe
Use the piping hole to mount the camera.
Mounting the camera using the piping hole at the bottom surface of the base
1. Setting the switches (A Pg. 20)
2. Removing the camera unit from the base. (A Pg. 21 , step 1)
3. Mount the fall prevention wire to the base (A Pg. 21)
4. Binding the sealing tape
Bind at least 2 layers of the sealing tape to the joint of the pipe (point where the thread of the piping hole coincides with the screw hole of the pipe).
5. Mounting the base to the pipe
Screw the base into the pipe by turning the base in the clockwise direction. (Piping hole:
Note:
●When screwing in the pipe, make sure that not more than 12 mm (15/32 inch) of the pipe is being screwed in. Failure to do so may damage the internal components of this unit.
6. Fastening the base to the ceiling
Fasten the base to the ceiling firmly using 2 RM4 mm screws.
Note:
●R4 mm screws are not supplied with this product. Use appropriate type of screw according to the material of the mounting place.
●Check to ensure that there is no space between the ceiling and base.
7. Mounting the fall prevention wire to a firm place (A Pg. 21)
4
Sealing Tape
12 mm(15/32 inch) and below
7
Fall Prevention Wire
5 3
8 mm
2 mm
6
R4 mm screw
8. The following procedures are same as normal mounting
●Cable Connection (A Pg. 22)
●Mounting the camera unit to the base (A Pg. 23)
●Adjusting Images (A Pg. 25)
●Mounting the inner dome (A Pg. 30)
●Mounting the dome cover (A Pg. 30)
32